Jupiter 303 00 Série Mode D'emploi page 4

Operating Instructions Manual All-Purpose Slicer
Congratulations on the purchase of your new
EN
JUPITER kitchen appliance. You have chosen a
high-quality, modern appliance. Further information
on this and other products is available on our website
at www.jupiter-gmbh.de.
This appliance is intended for slicing bread, sausage,
cheese etc. in normal domestic quantities in a domestic
environment or in domestic-like
tions.
Domestic-like applications
staff break rooms in shops, offices, agricultural and other
commercial businesses, small hotels and similar residen-
tial facilities. Only use the appliance for normal domestic
processing quantities and periods of time. The appliance is
maintenance-free.
Please read the operating instructions and, in particu-
lar, the safety notes, before using the appliance for
the first time.
Keep the operating instructions safe and always store
them with the appliance.
Model overview
Art. no. Description
302 001 With coated base plate
With high-quality base plate made
303 00X
from solid HPL
Important safety notes
CAUTION Sharp parts can cause injury!
The blade of the manual all-purpose slicer is very sharp!
Handle it with care.
• Children should not use the appliance. They should not
play with it either.
• This appliance may be used by persons with physical,
sensory or mental disabilities, or by those who lack ex-
perience and/or knowledge, if they are supervised or
have been instructed in the safe use of the appliance
and have understood the dangers involved..
• The appliance may only be repaired by JUPITER
customer service.
Scope of delivery
• Manual all-purpose slicer
• Crank handle
• Suction feet (x4)
• Table clamp (table top/worktop thickness approx.
2 - 6 cm)
• Operating instructions
4 Subject to technical changes without notice; no responsibility is accepted for the accuracy of this information.
applica-
non-commercial
include, for example, use in
Components of the manual all-purpose slicer
Thickness guide
A
Crank handle
B
C Suction feet
Base plate
D
Adjusting knob for slice thickness (0 - 20 mm)
E
F Blade (rust-proof)
Blade locking screw
G
Borehole for table clamp
H
A
H
G F
1
2
Assembly/Set-up
CAUTION Sharp parts can cause injury!
The blade of the manual all-purpose slicer is very sharp!
Handle it with care.
• Screw the 4 suction feet
plate D and press the all-purpose slicer onto the table.
• If required, push the table clamp into the borehole
the base plate and use it to secure the all-purpose slicer
to the table top/worktop (thickness approx. 2 - 6 cm).
• Screw the crank handle
B
dle thread until the blade turns.
B
E D
into the thread of the base
C
H
clockwise onto the crank han-
C
of