Utilisation; Nettoyage; Mise En Service; Réglage De La Température - Kelvinator KICT 333 HWF Mode D'emploi

Table des Matières

Publicité

MAINTENANCE
Unplug the appliance before carrying out
any maintenance operation.
Warning
This appliance contains hydrocarbons in its cooling
unit; maintenance and recharging must therefore
only be carried out by authorized technicians.
Periods of non-operation
When the appliance is not in use for long periods,
take the following precautions:
remove the plug from the wall socket;
remove all food;
defrost and clean the interior and all accessories;
leave the door ajar to allow air to circulate to prevent
unpleasant smells.
Interior light
The light bulb inside the refrigerator compartment
can be reached as follows:
- unscrew the light cover securing screw.
- unhook the moving part as shown in the figure.
If the light does not come on when the door is open,
check that it is screwed into place properly. If it still
does not light up, change the bulb.
The rating is shown on the light bulb cover.
Defrosting
Frost is automatically eliminated from the evaporator
of the refrigerator compartment every time the motor
compressor stops, during normal use. The defrost
water drains out through a trough into a special
container at the back of the appliance, over the
motor compressor, where it evaporates.
It is important to periodically clean the defrost
water drain hole in the middle of the refrigerator
compartment channel to prevent the water
overflowing and dripping onto the food inside.
Use the special cleaner provided, which you will
find already inserted into the drain hole.
The freezer compartment, however, will become
progressively covered with frost. This should be
removed with a plastic scraper, whenever the
thickness of the frost exceeds 4 mm. During this
operation it is not necessary to switch off the power
supply or to remove the foodstuffs.
44
Periodic cleaning
Many proprietary kitchen surface cleaners
contain chemicals that can attack/damage the
plastics used in this appliance. For this reason it
is recommended that the outer casing of this
appliance is only cleaned with warm water with a
little washing-up liquid added.
Clean the inside with warm water and bicarbonate of
soda.
Rinse and dry thoroughly.
Clean the condenser (black grill) and the
compressor at the back of the appliance with a
brush or a vacuum cleaner. This operation will
improve the performance of the appliance and save
electricity consumption.
D411
D037

UTILISATION

Nettoyage

L'appareil étant convenablement installé, nous vous
conseillons de le nettoyer soigneusement avec de
l'eau tiède savonneuse, pour enlever l'odeur
caractéristique de «neuf».

Mise en service

Enfoncez la fiche dans la prise de courant
Tournez le bouton du thermostat dans le sens des
aiguilles d'une montre au-delà de la position «O»
(arrêt).
Le voyant de fonctionnement s'allume.
Pour arrêter l'appareil tournez le bouton du
thermostat sur la position «O».
Réglage de la température
La température est réglée automatiquement et peut
être augmentée (moins froid) en tournant le bouton
vers les numéros les plus bas ou bien diminuée
(plus froid) en le tournant vers les numéros les plus
élevés.
En tout cas, l'exacte position doit être repérée en
considérant que la température interne dépend des
facteurs suivants:
température ambiante;
fréquence d'ouverture des portes;
quantité d'aliments conservés;
emplacement de l'appareil.
Important
Si le thermostat est réglé sur la position de froid
maximum, lorsque la température ambiante est
élevée et que l'appareil est plein, il est possible
que le compresseur fonctionne en régime
continu. Dans ce cas, il y a un risque de
formation excessive de givre sur la paroi
postérieure à l'intérieur de l'appareil. Pour éviter
cet inconvénient, placez le thermostat sur une
position moins élevée, de façon à permettre un
dégivrage automatique et, par conséquent, des
économies de courant.
N'utilisez pas de produits abrasifs, de
poudre à récurer ni d'éponge métallique.
Réfrigération
Pour obtenir le meilleur rendement du compartiment
réfrigérateur:
n'introduisez pas d'aliments encore chauds ou de
liquides en évaporation dans la cuve;
couvrez les aliments, surtout s'ils sont
aromatiques;
placez les denrées de façon à ce que l'air puisse
circuler tout autour.
17

Publicité

Table des Matières
loading

Table des Matières