17. PFL Level Display
The display shows the signal level of the mixer input you have selected with the Cue
buttons.
REAR PANEL
18. MICrophone Input
Two 1/4" jack sockets are mounted on the rear panel of the mixer for connecting your
microphone and offer both balanced or unbalanced microphone connections.
19. LINE/CD Inputs
These inputs are unbalanced RCA jacks, connect stereo audio from Hi Fi VCRs,
cassette and reel-to-reel tape decks, CD players, VDPs, Tuners, even synthesizers or
other mixing consoles.
20. PHONO Inputs
These inputs are unbalanced RCA jacks. Use these only for turntables with moving
magnet cartridges. Line level sources will overload these inputs. Moving coil
cartridges require a separate head amp for optimum sound.
21. Unbalanced BOOTH Outputs
These stereo outputs are low impedance, unbalanced RCA jacks controlled by the
Booth fader.
22. GND
The GND is a terminal for grounding turntables to eliminate hum.
23 Balanced Booth Outputs:
Master stereo program output provided by 3 pin Male XLR sockets controlled by the
Booth fader.
24. Balanced Master Outputs:
Master stereo program output provided by 3 pin Male XLR sockets controlled by the
Master A fader.
25. MAINS Connection
A standard IEC AC power socket for connecting to the main AC supply.
Before you connect your Mixer to the mains, please make sure that your local voltage
matches the voltage required by the unit!
26. FUSE Holder
The IEC power socket has an integral fuse holder that takes a 20mm fuse. Always
replace a blown fuse with the same type as specified on the rear of the Mixer.
7
27. PHONO/CD Selectors Switch
This switch selects between the PHONO and CD input on the rear panel.
28. USB Jack
The USB input/output channel is used for playing MP3 (or other audio) files from a
computer or for recording your performance to a computer.
This sends and receives audio data from your computer. The USB jack sends audio to
the mixer's channel PHONO/CD/USB.
Note: When connecting or disconnecting the USB cable be sure to turn the CHANNEL
PHONO/CD/USB control all the way down.
SPECIFICATIONS
Input Sensitivity/ Impedance: DJ MIC & MIC: 3mV / 1KOhms
PHONO: 3mV / 51KOhms (RIAA)
LINE: 150mV / 100KOhms
Output Level/ Impedance:
MASTER (Max. Output: 8V): 775mV/600Ohms Balanced
BOOTH (Max. Output: 8V): 775mV/600Ohms Balanced
775mV/600Ohms Unbalanced
PHONES (Max Output: 420mV): 380mV/8Ohms
Frequency Response: 20Hz~20KHz ± 0.5dB (RIAA ±2dB)
Total Harmonic Distortion: 0.01% (Rated output)
Stereo Separation: More than 45dB
Signal-To-Noise Ratio: DJ MIC & MIC: 80dB
PHONO: 70dB
LINE: 85dB
Tone Control: Boost/Cut@Center Frequency: ±12dB@100Hz,10KHz
Talkover Reduction: 0 to -20dB
USB Interface
A/D & D/A: 16 bit Delta Sigma
Playback Distortion < 0.05%
S/N: 80dB
Recording Distortion < 0.1%
Interface: USB1.1 or USB2.0 with full-duplex operation (playback and recording)
Dimensions: 482mm* 221.5mm* 105mm
Weight: 3,5kg
CAUTION: The apparatus shall not be exposed to dripping or splashing and that no
objects filled with liquids, such as vases, shall be placed on the apparatus
.
54IN909.011409
8
7