Installer Setting - LG PRARH0 Manuel D'installation

5. Installer Setting

5. Installer Setting
CAUTION
Installer setting mode is to set the detail function of the remote controller.
If the installer setting mode is not set correctly, it can cause problems to the product, user
injury or property damage. This must be set by an certificated installer, and any installation
or change that is carried out by a non-certificated person should be responsible for the
results. In this case, free service cannot be provided.
Wired Remote Controller - PQRCVSL0/PQRCVSL0QW
Setting feature for indoor unit when Auxiliary Heater Relay Kit is newly installed, or installed unit is removed.
14 Auxiliary Heater Relay Kit
If pressing button long for 3
1
seconds, it enters into remote
controller setter setup mode.
- If pressing once shortly, it enters
into user setup mode. Please press
more than 3 seconds for sure.
If pressing button repeatedly, it moves to
2
the selected option function code as picture
below.
Select existing condition
3
of each mode by pressing
button.
(00: not installed,
01 : installed)
Function Code Existing condition
Press button to save.
4
5 Pressing button will exit settings mode.
❈ After setup, it automatically gets out of
setup mode if there is no button input for
25 seconds.
❈ When exiting without pressing set button,
the manipulated value is not reflected.
Function Code
Aux Heater Relay Kit 25