Federal Signal Corporation AM30 Instructions D'installation Et D'entretien page 3

INSTALLATION AND SERVICE INSTRUCTIONS FOR MODEL AM30 SPEAKER
SAFETY MESSAGE TO INSTALLERS, USERS AND MAINTENANCE PERSONNEL
It is important to follow all instructions shipped with this product. This device is to be installed by a
trained electrician who is thoroughly familiar with the National Electrical Code and will follow NEC
Guidelines as well as local codes.
The selection of the mounting location for the device, its controls and the routing of the wiring is to
be accomplished under the direction of the facilities engineer and the safety engineer. In addition,
listed below are some other important safety instructions and precautions you should follow:
• This is not a Listed safety device and is not intended to be used as such.
• Read and understand all instructions before installing or operating this equipment.
• Disconnect power before connecting or doing any maintenance on this device.
• All effective warning speakers produce loud sounds which may cause in certain situations,
permanent hearing loss. You should take appropriate precautions such as wearing hearing
protection.
• All effective warning speakers produce loud sounds, which may cause, in certain situations,
permanent hearing loss. The device should be installed far enough away from potential listeners to
limit their exposure while still maintaining its effectiveness. The OSHA Code of Federal
Regulations 1910.95 Noise Standard provides guidelines which may be used regarding permis-
sible noise exposure levels.
• After testing is complete, provide a copy of this instruction sheet to all operating personnel.
• Establish a procedure to routinely check the speaker installation for integrity and proper
operation. Any maintenance must be performed by a trained electrician in accordance with NEC
guidelines and local codes.
Failure to follow all safety precautions and instructions may result in property damage, serious
injury, or death to you or others.
A. Description.
The Federal Signal Model AM30 is a conservatively rated 30-watt constant-directivity paging
projector for use in any public address or paging application.
The driver employs a rugged phenolic diaphragm, 1.5-inch diameter voice coil, and "rim
centered" ferrite magnet structure for long life and durability under extreme operating
conditions.
A 12-inch connecting cable, phased and color coded, is provided for connecting to the AM30.
A nominal 60° horizontal by 40° vertical coverage pattern together with a low-frequency cutoff
of 350 Hz provides excellent articulation in demanding applications.
The AM30 is molded from high-impact ultraviolet inhibiting ASA (acrylic styrene acryloni-
trile). A positive lock super tough nylon swivel base provides maximum mounting flexibility
and ease of installation.
Ideal for both indoor and outdoor applications, these drivers are well suited for any installation
requiring rugged, reliable performance.
B. Model AM30 Specifications.
Frequency Response:
Power Handling:
Impedance:
Nominal
Minimum, above 500 Hz
400-6500Hz ±5 dB
30 watts
8 ohms
6.5 ohms (650Hz)