AA-drill 77345 Manuel D'instructions page 18

Voltage warning:
a. Before connecting the tool to a power source (receptacle, outlet, etc.) be sure
the supplied voltage is the same as the rating on the tool itself.
b. A power source with voltage greater than that specified for the tool can result
in serious injury to the user.
c. If you're unsure of the voltage rating, do not use tool. Also using a power
source with voltage less than that of the tool will harm the motor.
Grounding instructions:
a. While in use should be grounded to protect user from electric shock.
b. If tools is equipped with approved three-conductor cord and three-prong
grounding plug, it fits a grounding receptacle when using an adapter to
connect a three prong plug to a two prong receptacle. The adapter plug must
be attached to a permanent ground.
Additional safety rules for drill presses:
a. Be sure drill bit or cutting tool is securely locked in the chuck.
b. Be sure chuck key is removed from the chuck before turning on power.
c. Adjust the table or depth stop to avoid drilling into the table.
d. Shut of the power, remove the drill bit or cutting tool, and clean the table
before leaving the machine.
e. Caution when practical. Use clamps or a vise to secure workpiece to keep the
worktpiece from rotating with the drill bit or cutting tool.
Warning: do not wear gloves while operating drill presses!!!
General assembly instructions:
Screw column to base, assemble press head to column and tighten set screw with
hex key. Attach handles chuck etc, upon completion of assembly. Drill press can
be washed with kerosene to remove anti-rust oil applied at factory, then lubricating
oil can be applied.
Round-out tolerance:
For drilling operations require close tolerances, place drill blank in the chuck and
check round-out with a dial indicator. If the round-out is not within desired
tolerance, tap the chuck bottom with a rubber or leather mallet until you get the
desired tolerance.
Operation directions:
The following directions will give the operator not familiar with the drill press
operations a start. Use scrap material for practice to get the feel of the machine
before attempting regular work.
A Correct drilling speeds: Factors which determine the best speed to use in
any drill press operation are based on the material being worked, size of hole, type
of drill or other cutter and quality of cut desired. The smaller the drill, the greater
16