Instructions For Operation; Instructions For Maintenance - Roca AQUAKIT HOTEL'S 1600 Manuel D'installation Et D'utilisation

INSTRUCTIONS FOR OPERATION

The inverter switch on the Aquakit Hotel's hydromassage column
allows the following functions to be selected:
Shower head
Upper hydromassage jets
Central hydromassage jets
Lower hydromassage jet
Lower water outlet (feet-bath)
Simply turn the inverter switch towards the desired position (Fig.7),
moving it in either direction, even when the water is running.
The thermostatic fitting regulates the temperature by activating the
thermostatic cartridge (Fig.8). If the boiler goes out on too many
occasions and the water is cold when using any of the column
functions, first of all clean the filters of the thermostatic fitting, and
if the problem persists, lower the outgoing hot water temperature
of the boiler or the heater by means of the control on the unit itself,
and if possible increase the outflow, whereby more water will reach
the cartridge, which will regulate the temperature correctly.
As with all tap systems, if your hot water generator is an instant
heater or a mixed boiler without an accumulation tank, there may
be temperature variations when a low volume of hot water is
required and it is not sufficient to keep the boiler or heater in
operation.
When this happens, the effect can be reduced by lowering the
trigger temperature of the boiler or heater to a level that is slightly
higher than the desired value
To adjust the position of the jets, these can be moved, so turn
them towards the optimum position as required. The type of
massage can be selected in the same way, with independent
adjustments for the power and type of spray from each jet. Fig. 9.
The shower head has a multifunctional sprinkler, and the type of
spray or preferred massage can be selected by turning the outer
ring on the head, Fig. 10.

INSTRUCTIONS FOR MAINTENANCE

The Aquakit Hotel's column is made of anodised aluminium, and
so to maintain it correctly, the following recommendations should
be observed:
- Do not clean it with abrasive products or scourers, or devices
that produce steam; only use water, soap and a soft cloth.
- Avoid scratching the column with metal or sharp objects.
11