ProFlow PF-PHN Mode D'emploi page 9

1. Press the scroll button repeatedly until the display
shows:
Holiday: OFF
•
•
Press the up or down
holiday mode by setting the number of full days away
from home, or deactivate the holiday mode (OFF).
Once the control panel is back in service mode, the display
will show:
8:01 Holiday

The holiday mode is automatically cancelled when a
regeneration is manually initiated!
PROGRAMMING INSTRUCTIONS -
BASIC SETTINGS

Before entering the programming mode, make sure that
the appliance is in the service mode.

In case no button is pressed in a period of 5 min, the
control panel will automatically return to the service mode;
any changes made will NOT be saved!
1. Press the scroll button and hold it for 2 sec until the
display shows:
Language:English
•
Press the up or down
language.
2. Press the scroll button again; the display will show:
Set time:
•
Press the up or down
day.
3. Press the scroll button again; the display will show:
Interval:7 Days
•
Press the up or down
of days between regenerations.
4. Press the scroll button again; the display will show:
Buzzer: ON
•
Press the up or down
disable the buzzer.
ELECTRONIC CONTROL PANEL
button to activate the
button to set the
8:01
button to set the time of
button to set the number
button to enable or
5. Press the scroll
Exit
•
Press the up
into the NOVRAM® and exit the programming mode.

The regeneration cycle is necessary to prevent 'caking'
of the filter media during the service cycle, which may result
in an increase of pressure drop over the appliance. Typically
a regeneration every 7 days should be sufficient. In case of
high flow rates, excessive water usage or a high
concentration of impurities in the incoming water, it may be
necessary to lower the number of days between
regenerations.
Page 9
button again; the display will show:
or down button to save the settings
EN - English