Unpacking And Checking; Unpacking The Accessories And Parts; Contents Of Package; Installation And Use Of Wall Mount - Bosch SmartGrow Life Wall Mount Set Manuel D'utilisation

en Unpacking and checking

Unpacking and checking

2 Unpacking and check-
ing
Find out here what you need to note
Unpacking and checking
when unpacking the appliance.
2.1 Unpacking the accessor-
ies and parts
Take the accessories out of the
1.
packaging.
Take all other parts and the ac-
2.
companying documents out of the
packaging and place them to
hand.
Remove any packaging material.
3.
Remove any stickers or film.
4.
2.2 Contents of package
After unpacking all parts, check for
any damage in transit and complete-
ness of the delivery.
→ Fig.
1
Wall mount
A
Screws for wall mounting (2x)
B
Wall plugs for wall mounting
C
(2x)
Screws for securing docking
D
unit (2x)
Accompanying documents
E

Installation and use of wall mount

3 Installation and use of
wall mount
Prepare the accessory for use.
Installation and use of wall mount
3.1 Fitting the wall mount
Note: The enclosed screws and wall
plugs are suitable for use with solid
masonry made of bricks or concrete.
8
Suitable fasteners must be used for
other structures (e.g. plasterboard,
aerated concrete, Poroton blocks).
Mark the holes for the wall mount.
1.
Check that there are no electric
cables, gas or water pipes in the
area where holes are going to be
drilled.
Drill the holes.
2.
Fit the wall mount on the wall us-
3.
ing the wall plugs and screws.
When doing so, do not tighten the
screws fully.
→ Fig.
2
Pass the device plug of the power
4.
supply through the opening in the
wall mount. Tighten the screws.
→ Fig.
3
Check the alignment using a spirit
level.
3.2 Fitting the device to the
wall mount
Insert the device plug in the dock-
1.
ing unit.
→ Fig.
4
Fit the docking unit onto the wall
2.
mount and secure from below with
the screws supplied.
→ Fig.
5
Note: See the instruction manual for
your smart indoor gardening device
to find out the essentials for prepara-
tion and use.