Favero Electronics FC Série Mode D'installation Et D'emploi page 18

E NG LISH
9.6. Replacing the FC HUB board
1. Open the power supply module as described in chapter 9.2.
2. Remove all the connectors from the board, taking note of their original position.
3. Unlock the 4 fixing elements of the board and remove it from its seat.
4. Mount the new board in the same seat of the old one.
5. Insert the connectors in their original position.
Fig. 8 Replacing a FC HUB board.
9.7. Replacing the radio module
1. Open the power supply module as described in chapter 9.2.
2. Remove the connector from the module.
3. Unscrew the 2 fixing elements of the protection cover and remove the assembly from its seat.
4. Mount the new module in the same seat of the old one.
Fig. 9 Replacing the radio module.
9.8. Replacement of the power supply unit
1. Depending on the models, one or two power supply units may be present.
2. Open the power supply module as described in chapter 9.2.
3. Disconnect all the connections taking note of their position.
4. Remove the support bracket fixing elements and extract the assembly.
16
/ 94 00304-M02-03 - ML-FC serie scoreboards - User Manual Rev03 - 160826 -
1. FC HUB board.
2. Board fixing.
1. Radio module.
2. Module fixing.
FAV E RO E L EC T RO NIC S