Publicité
Les langues disponibles
Les langues disponibles
OPERATING INSTRUCTIONS
FEATURES
1. Glass body
2. Spout
3. Lid
4. Lid button
5. Handle
6. Power switch
7. Base
8. Power indicator light
3
2
1
8
FIRST TIME USE
It is recommended to clean the kettle before using it
for the fi rst time.
Fill the kettle to the maximum capacity and set
the water to boil. Once boiled, discard this water.
Complete this process twice to remove any dust from
the inside of the kettle.
The maximum capacity of the kettle is 1.2 litres.
4
5
6
7
OPERATION
Always use the kettle on a fl at, stable surface.
To fi ll the kettle, remove it from the power base and
press the lid button to open the lid. Fill the kettle with
the desired amount of water and close the lid.
IMPORTANT: Be sure not to overfi ll the kettle to
avoid spillage of boiling water.
The kettle should be fi lled between the minimum
and maximum indicators on the side. If there is
not enough water, the kettle will shut off before the
water is boiled. If there is too much water, boiling
water could spill and cause injury.
Replace the kettle on the power base and connect
the plug to a power outlet.
Press the power switch and the power light will
illuminate to indicate that the kettle is heating.
IMPORTANT: Ensure that the power switch is free of
obstruction and that the lid is fi rmly closed.
The kettle will turn off automatically once the water
is boiled.
IMPORTANT: Be very careful when pouring boiling
water. Hot water and steam can cause burns and
scalding. Do not open the lid while the water is still
hot.
When the kettle turns off, the power switch cannot
be pressed again for 30 seconds to allow the
internal circuit to reset.
The kettle can be stored on the power base.
Unplug the kettle when not in use.
3
Publicité
