Safety Notes And Limit To Operation; Limit To Operation In Coolin Mode; Limit To Operation In Heating Mode - Ferroli MIDAS PC10 12000 Manuel D'installation

SAFETY NOTES AND LIMITS TO OPERATION
Strictly comply with the following regulations to prevent injuries to the operator or damage to the machine.
•This technical operation and maintenance manual is an integral part of the machine. It must be kept with care and
be ready to hand should the operators require it for consultation.
• Failure to comply with the instructions in this manual and inadequate installation of the conditioner may void the war-
ranty certificate. Moreover, the Manufacturer shall not be liable for direct and/or indirect damages due to incorrect
installation or for damages caused by conditioners installed by inexpert or unauthorized personnel.
• Only specialized and authorized persons may install and service the units.
• Work in a clean, uncluttered place when installing the equipment.
• It is absolutely forbidden to touch moving parts or to move between the same.
• Before starting the conditioner, make sure that the various components and the entire system are in perfect and safe
conditions.
• Strictly comply with the routine maintenance operations.
• Insist on genuine spare parts. Failure to do so will void the warranty.
• Do not remove or tamper with the safety devices.
• Disconnect the electric power source before proceeding with any work on the machine.
• Do not place anything on the banks and/or top part of the unit.
• Do not push items through the protective fan grilles or allow objects to drop through them.
• The bank surface is sharp. Do not touch it without protective gloves.
• The interior unit is precharged with coolant gas. Prevent it from accidentally escaping.
• Carefully read the stickers on the machine, never cover them and replace them immediately should they be dama-
ged.
• Do not use the machine in an explosive atmosphere.
• The power line must be regularly grounded.
• If the power cable has been damaged, stop the machine if it is operating, and have the cable immediately replaced
by an authorized electrician.
• The power line of all models must be isolated prior to the air conditioner, by an automatic circuit-breaker with a cut-
out power of not less than 4.5kA, at the user's charge.
• The machine must be stored at a temperature between -25°C and 55°C.
• Use a powder extinguisher in the event of a fire outbreak. Do not use water.
• If the machine operates in an abnormal way, make sure that this does not depend on failure to carry out routine
maintenance. If this is not the case, have the machine checked by a specialized technician.
• If the exterior unit must be dismantled, it is advisable to have the job done by an authorized technical service cen-
ter.
• The machine must not be dumped if it is to be scrapped since it contains materials that must be recycled or dispo-
sed of by authorized centers.
• Do not wash the machine with direct or pressurized jets of water or with corrosive substances.
The Manufacturer and after-sales network are at your disposal for prompt and accurate technical assistance
and for anything else able to ensure the best operation and achieve the utmost efficiency from your machi-
ne.
LIMITS TO OPERATION IN COOLING MODE
Type of operation
Maximum inlet air temperature of I.U.
Maximum inlet air temperature of O.U.
Minimum inlet air temperature of I.U.
Minimum inlet air temperature of O.U.
Electric power supply (voltage variation)
Electric power supply (frequency variation)
LIMITS TO OPERATION IN HEATING MODE
Type of operation
Maximum inlet air temperature of I.U.
Maximum inlet air temperature of O.U.
Minimum inlet air temperature of I.U.
Minimum inlet air temperature of O.U.
Electric power supply (voltage variation)
Electric power supply (frequency variation)
8
(1)
(1)
(1)
(1)
(1)
(1)
(1)
(1)
Cooling mode
(°C) 32 D.B.
43 D.B.
(°C)
(°C) 16 D.B.
(°C) 21 D.B.
(V) ±10%
(Hz) ±2
Heating mode
(°C) 27 D.B.
(°C) 24 D.B.
(°C) 20 D.B.
-7 D.B.
(°C)
(V) ±10%
(Hz) ±2
23 W.B.
-
15 W.B.
-
-
18 W.B.
-
-8 W.B.