Maintenance, Care And Decalcification; Description And Contents - Reer NewGen Mode D'emploi

2. Maintenance, care and decalcification

Maintenance, care and decalcification
Cleaning
Always unplug the device before cleaning! Never submerge power supply cord and housing base
in water, wipe it with a dry cloth. The outer side of the device can be wiped with a wet cloth.
Decalcification
Depending on use and the degree of hardness of tap water used, lime deposits can be formed
in evaporator section at the bottom. To ensure proper function of the device, lime rims should be
regularly removed.
nOTe:
We recommend to clean small lime deposits using household vinegar as described below. For
masive deposits, commercially available lime solvents should be used - it is important to observe
manufacturer's instructions.
Descaling with clear vinegar: Mix 100 ml hot water with 100 ml vinegar, then pour it into the
evaporator part at the bottom. Leave to soak for ca. 30 minutes, then empty it. Rinse and wipe
subsequently with wet cloth.
important: Do not use abrasive cleaning agents or scouring pads.
When descaler or citric acid is used, do not allow cleaning solution boiling down! Switch off or
unplug the device after it came to the boil. Rinse the device thoroughly
Technical characteristics
Power supply: 230 V / 50 Hz | 350 W
The device complies with directives no. 2004/108/EG for electromagnetic compatibility
and no. 2006/95/EG for safety.
a) Cap
b) Cover
c) Measuring cup (125 ml)
d) Evaporation boat (base unit)
e) Grille insert
f) Power button
g) Turning knob for temperature (time)
e
f
g
page 8

3. Description and contents

tIp:
reer organic decalcifier
Item no. 3699
a
b
c
d