Schumacher Electric 98026071 Guide De L'utilisateur page 11

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

2.5
EXTENSION CORD USE
For optimum welder performance, an extension cord should not be used
unless absolutely necessary. If necessary, care must be taken in selecting
an extension cord appropriate for use with your specific welder.
Select a properly grounded extension cord that will mate the ac power
cord of the welder with the ac power source receptacle directly, without
the use of adapters. Make sure the extension cord is properly wired and in
good electrical condition.
For an extension cord not exceeding 25 feet in length, choose the same
aWG wire size as that of the power cord on the welder. extension cord
lengths longer than 25 feet will require heavier wire gauges to compensate
for voltage losses.
2.6
INSTALLING THE ELECTRODE HOLDER
attach the electrode holder to the electrode cable according to the
following steps.
1.
Remove the handle (3) from the electrode holder (1) by removing the
screw holding the handle (not shown) and sliding the handle off.
2.
Remove the screw (6) from the electrode holder (1).
3.
Push the cable (4) through the handle (3).
4.
Insert the screw (6) through the hole in the electrode holder, then
through the cable lug (5) and thread into the Rectangular Mounting Nut
(2).
5.
Slide the handle back onto the electrode holder body (when it is
aligned properly it will slide on easily). Press the two parts together and
reinsert the screw to hold the handle in place.
8

Publicité

Table des Matières
loading

Table des Matières