Programming A Learned Key - Shaw ATLAS Mode D'emploi

• Learned keys are mode-specific, so each one can
store a unique function for each mode.
• Do not use the following keys for learning: Device
Keys, SETUP, Record (•), Tune-In Keys.
• Learning capacity is approximately 16 to 25 keys,
depending on the code being learned.
• Certain device functions are not learnable including
multi-frequency types, some high frequency ones,
and other unusual formats.
• For optimum learning, avoid high levels of ambient
light such as natural sunlight or energy-efficient
fluorescent lights.
Please have your original remote controls
NOTE:
handy before programming learning.

Programming a Learned Key

NOTE: If more than 15 seconds pass between key
presses, the remote exits programming.
1. Press SETUP until the last-selected device key
blinks twice, then press 9 7 5.
NOTE:
If the LED displays one long flash instead,
either your batteries are low, or the Atlas Shaw
DVR/PVR 5-Device Universal Remote Control
has a memory fault. In either case, the remote
will not learn a new key. See "Additional Infor-
mation" on page 23.
2. Press a device key once (i.e., AUX, DVD, AUD,
TV, or CBL) to assign a mode for learning, then
the key that will learn the new code.
3. Place the Atlas Shaw DVR/PVR 5-Device
Universal Remote Control head-to-head
(about 2" apart) from your original remote
control. Also locate the key (on your original
remote control) that you want the Atlas Shaw
DVR/PVR 5-Device Universal Remote Control
to learn.
4. On the original remote, press and hold the key
to be learned. The Atlas Shaw DVR/PVR 5-
Device Universal Remote Control's LED will
13
2"