Insulation Of The Floor; The Door - Fondis C50S Mode D'emploi

Winemaster C50S(SR) USER MANUAL

6.5. INSULATION OF THE FLOOR

The floor of the cellar must be able to support the shelves and the stored wine Thus it is necessary to choose an
insulation with an adequate compression strength. The load capacity of each insulating material should be noted
on the manufacturer's label. Another possibility is to cover the insulation with an insulating material designed
specifically for floors such as quality chipboard.
Improve the load capacity of the insulation (particularly under the shelf legs) by:
Using "complex" insulating panels covered by panels of higher load capacity.
Covering the floor insulator with quality chipboard (with a thickness of 15 mm) or with an other
appropriate material.
6.6. THE DOOR (Optional)
An adequately insulated door can be obtained in one of two ways:
Insulate an existing door with the same insulating materials used for the walls of the cellar. Provide a tight seal
between the door frame and all sides of the door with a strip of foam rubber, for example.
Use a specially designed FONDIS Isothermic door containing polyurethane. In this case you are assured to have
a tight seal on all sides of the door which is equipped with a magnetic joint.
FONDIS Isothermic Door
Exterior dimensions:
Door opening:
The following accessories are delivered with the door:
- 4 steel edges to be fixed to the frame by the brass nails
- 2 hinged brackets to be fixed by the wood screws
- 1 latch plate
1900 mm x 630 mm
1860 mm x 590 mm
Page 18
May 2003