Nicols BEAM LED Manuel D'utilisation page 2

MANUEL D'UTILISATION
CAUTION!
Keep this device away from rain and moisture! Unplug mains lead before opening the
housing!
Every person involved with the installation,
operation and maintenance of this device
has to:
-Be qualified
-Follow the instructions of this manual
SAFETY INSTRUCTIONS
♦ CAUTION! Be careful with your operations. With a dangerous voltage you can suffer a
dangerous electric shock when touching the wires!
♦ This device has left our premises in absolutely perfect condition. In order to maintain this
condition and to ensure a safe operation, it is absolutely necessary for the user to follow the
safety instructions and warning notes written in this user manual.
♦ Important: Damages caused by the disregard of this user manual are not subject to
warranty
The dealer will not accept liability for any resulting defects or problems.
♦ Keep away from heaters and other heating sources!
♦ If the device has been exposed to drastic temperature fluctuation (e.g. after transportation),
do not switch it on immediately. The arising condensation water might damage your device.
Leave the device switched off until it has reached room temperature.
♦ If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively
replaced by the manufacturer or his service agent or a similar qualified person in order to
avoid a hazard.
BEAM LED
♦ Shields, lenses or ultraviolet screens shall be changed if they have become visibly damaged
to such an extent that their effectiveness is impaired, for example by cracks or deep
scratches.
♦ Always disconnect from the mains, when the device is not in user or before cleaning it.
♦ Keep away children and amateurs from the device!
♦ There are no serviceable parts inside the device. Maintenance and service operations are
only to be carried out by authorized dealers.
FUNCTION DESCRIPTION
1. Initial Mode: LED changes every second. After changing 5times,motor will run(about 30s a
circle, In this condition,the sound mode is OK.)
2. Sound Mode: LED color change with motor running condition
3. NON-sound Mode: After few seconds,motor runs slowly,led changes every 5s.LED color
change like belows. After one minute, non-sound mode stop(DC motor stops,LED off).
R G B→RB→RG→GB→RB→RGB
TECHNICAL SPECIFICATIONS
Power input ： A C 240V - 60Hz
Switch Power ： I N AC 100-240V 50/60Hz OUT DC12V/3A
Maximize consumption 3 0W
：
DC motor: 35 ram/min
LED System ： R GB/3IN1/3W
Dimension (LXWXH):315 x 185 x 341 mm
Weight: 3.86Kg