Usage - Beurer Barbers Corner HR 4000 Mode D'emploi

3. After use, pull the mains adapter out of the socket and the device.
WARNING
Never use the device in the shower when it is being operated via the mains.
The hand-held part of the device must be disconnected from the connection cable before use in a
damp environment.

8. Usage

Travel lock
The device has a travel lock. If the travel lock is activated, it is not possible to switch on the device. The
travel lock prevents the device from switching on by accident (e.g. when transporting it in a suitcase).
To activate the travel lock, press and hold the ON/OFF button
cator begins to flash. The device is now locked. If the ON/OFF button
device is locked, the travel lock indicator will light up in the display to indicate that the device is locked.
To deactivate the travel lock, press and hold the ON/OFF button
Direct drive function
If the battery is completely flat, you can continue using the device immediately via mains operation.
Changing the trimmer attachment and slim contour blade attachment
The device has two attachments. The trimmer attachment and the slim contour
blade attachment. To switch the trimmer attachment, for example, proceed as
follows:
1. Switch off the device.
2. Hold the device with the rear turned towards
you. Twist the trimmer attachment to the right.
3. Pull the trimmer attachment up and off.
Place the slim contour blade attachment
onto the device from above, so that it sits completely on the device.
4. Twist the slim contour blade attachment to the left until it clicks into place.
Attaching/removing comb attachments
The device has three comb attachments. A long comb attachment, a short comb attachment and a
comb attachment for the slim contour blade.
Note
The long and short comb attachments are only suitable for use with the trimmer attachment.
The comb attachment for the slim contour blade can also only be used with the slim contour blade
attachment.
for 3 seconds. The travel lock indi-
again for 3 seconds.
22
is briefly pressed when the