Publicité
Les langues disponibles
Les langues disponibles
3. To stop the repeat function, press the REPEAT button a third time and the repeat indicator will
disappear.
FORWARD/REVERSE SKIP
1. Press >> button to skip ahead to the beginning of the next track. Press this button again for each
additional track you want to skip.
2. Press << button to skip back to the beginning of the current track. Press this button again for each
additional track you want to skip.
PROGRAMMING THE CD PLAYER
You can program up to 20 tracks in arbitrary sequence. You can also program a track more than once.
1. Before programming always press STOP and then press the PROGRAM button. On the display
you can see „P01" and „PROG" blinking.
2. Use << SKIP REV. or >> to select a desired track.
3. Press „PROGRAM"once to store the track. The indicators „P02"and „PROG"are blinking on the
display. Please select the next track.
4. Press PLAY/PAUSE to start playback of the programmed tracks.
RADIO OPERATION
ANTENNAS
AM - This unit has a built-in ferrite rod antenna, which eliminates the need for an external antenna, and
provides adequate reception in most areas. If reception is weak, turn the unit to improve the reception.
FM - The telescopic antenna on the top of the unit is for FM reception only. If reception is weak, adjust
the length and the angle of the antenna.
LISTEN TO A RADIO STATION
1. Set the FUNCTION selector to FM/AM position.
2. Tune into a desired station by rotating the TUNING KNOB (Fig A).
3. Adjust VOLUME control (16) to suit your personal listening preferences.
TECHNICAL SPECIFICATIONS
Power requirements
Dimensions unit
RECEIVER SECTION
Receiving bands
FM tuning range / sensitivity
CD PLAYER SECTION
Playback system
Frequency response
AUDIO SECTION
Power output
* Specifications and features are subject to change without prior notice
AC 230V ~ 50Hz ; 12 Watts
264 mm (W) x 174 mm (D) x 90mm (L)
AM/FM
AM 540 -1600kHz
FM 88 - 108 MHz
3 - beam laser pick-up
00 - 18000Hz
0.8 Watts X 2
4
Publicité
