Keso Mozy Eco Switch Configuration / Model V2; Mode Of Operation And Led's - KESO MOZY eco Manuel D'utilisateur

EN – User Manual KESO MOZY eco
3.2.2

KESO MOZY eco Switch Configuration / Model V2

Basic Switch Configuration
The functions are configured by using switch. The factory configuration is as
follows: door locking to the left, standard lock with latch bolt, learning mode
deactivated.
The table below shows all the combinations that can be obtained with the
switch (see Figure F – Switch positions V2)
SW1
left
1 Door locking to left Door locking to right
2 Standard lock Panic lock
3 With latch bolt Without latch bolt
4 Spare Spare
5 Spare Spare
6 Spare Spare
7 Learning deactivated Learning activated
8 Spare Spare
Note:
Operate the DIP switch carefully with tweezers or a small
screwdriver.
"Panic" Function Switch
Switch 2 must be closed if a panic lock is used. Make sure that the internal lock
contact is connected to terminal X6/2 (RK) and X6/3 (GND) (see Figure E).
10/2008
3.2.3

Mode of Operation and LED's

Power On Mode
The LED flashes green/red and the KESO MOZY eco switches to the learning or
setup mode after five seconds.
Setup
In setup mode, the LED is yellow as long as the motor is running.
Learning Mode
The learning mode is activated by inserting jumper J7 / Switch 7 while pressing
right the KESO MOZY eco button. During learning, the LED flashes green. The LED is
yellow when the motor is running from one stop to another. If jumper J7 /
Switch 7 is not removed after learning, the LED is red when the door is closed
and green when the door is open.
Normal Operation
If the door is locked, the LED is red.
If the door is unlocked, the LED is green.
Repeat Test Mode
The KESO MOZY eco tries to close the door and the LED flashes yellow during
the breaks between the test phases. If the KESO MOZY eco tries again, the LED
is yellow.
Error Mode
The LED changes colour: off / green / red / yellow. A buzzer also sounds.
suject to change without notice Page 30 from 48 pages