Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION REQUIREMENTS
TOOLS AND PARTS
Gather the required tools and parts before starting installation.
Tools needed for all installations:
Flat-blade screwdriver
1/4" nut driver
(recommended)
Tape measure
Utility knife
Caulking gun and compound
(new vent installations)
Min. 8" long Torx
T25
®
screwdriver
(for door reversal only)
® TORX is a registered trademark of Acument Intellectual Properties, LLC.
4
#2 Phillips screwdriver
Level
Pliers
Tin snips (new vent
installations)
Adjustable wrench that
opens to 1" (25 mm) or
hex-head socket wrench
Tools needed for gas installations:
8" or 10" pipe wrench
Pipe-joint compound
resistant to LP gas
Parts supplied:
Parts package is located in dryer drum. Check that all parts
are included.
NOTE: Do not use leveling legs supplied with dryer if installing
on a pedestal.
Leveling legs (4)
Short inlet hose
Rubber washers
Parts needed:
(Not supplied with dryer)
Vent clamps
■
Vent elbows and ductwork
■
Additional parts may be required, depending in your installation.
Check local codes. Check existing electrical supply and venting.
See "Electrical Requirements" and "Venting Requirements"
before purchasing parts.
8" or 10" adjustable wrench
(for gas connections)
"Y" connector
Long inlet hose
Publicité
Table des Matières
