emerio CME-125129 Mode D'emploi page 6

CME-125129
PARTS DESCRIPTION
1. Top cover
2. Tray
3. Power on/off switch with indicator light
4. Reservoir with water level indication
5. Jug
6. Brewing chamber
7. Filter basket
8. Reusable mesh filter
9. Lid of jug
10. Anti-drip function
OPERATION
Before first-time use:

Before using this device for the first time please carefully rinse all detachable components with warm
water.

Fill the reservoir with cold water to the maximum water level indication.

Afterwards brew water twice without coffee powder.
To percolate coffee:
1. Fill the reservoir with cold water.
2. Open the top cover and fill the reservoir to the desired water level indication. The maximum capacity is 1.5L
(approximately 12 cups).
3. Place the reusable mesh filter into the filter basket and place the filter basket into the brewing chamber.
Use the measuring spoon to add the amount of coffee powder appropriate to the amount of cups you want
to brew. Close the top cover.
4. Now place the jug on the tray of the appliance. Make sure the lid of jug is closed in order to unlock the
anti-drip function.
Note: The appliance is designed with an anti-drip function. You can temporarily remove the jug and pour
out coffee during brewing cycle without coffee dripping from the appliance within 30 seconds.
5. Plug the power cord into an appropriate outlet. Press the power on/off switch to start brewing coffee. The
indicator light will illuminate.
6. Remove out the jug to serve when finish brewing (about one minute later after the coffee stops dripping
out.).
- 5 -
EN