3 2 Remoset Function - JTS RU-G3TH/5 Mode D'emploi

2) Press the button SET repeatedly until the
menu item desired is shown
3) Use the button
setting; then press the button SET again to
save the setting The display will briefly show
StorE as a confirmation; then the menu will
be exited
4) To exit the menu without any changes, press
the button SET repeatedly until CAnCEL is
briefly shown on the display
Menu item Setting
Group 1 – 6 and channel 1 – 22*
For simultaneous operation of multiple
wireless microphones, 6 groups with up
to 22 channels each have been defined
(see page 15). The number of channels
from a group that can be used at the
same time depends on the conditions at
the place of application.
First set the group number (left digit),
then press SET and set the channel num-
ber. Press SET to save the settings.
Transmission frequency*
as an alternative to selection of group
and channel
First adjust the frequency in steps of
1 MHz, then press SET and make a fine
adjustment in steps of 0.025 MHz. Press
SET to save the adjustments.
Microphone sensitivity
to match the microphone to the volume
of the voice / instrument
Adjust the sensitivity according to the
indication AF of the receiver in such
a way that an optimum signal level is
obtained. If the sensitivity is too high,
the microphone signal will distort; in this
case, press the button
value (min. −15 dB). If the volume is too
low, there will be a poor signal-to-noise
ratio; in this case, press the button
set a higher value (max. +15 dB).
* For interference-free transmission, switch off the micro-
phone and set the group and the channel or the frequency
on the receiver. If no interference or signals of other trans-
mitters are received, switch on the microphone and make
the same settings on the microphone.
or (9) to make the
 
to set a lower

Menu item Setting
Fig. 4 Setting options via the menu
4.3.2 REMOSET function
For the REMOSET function, make sure that
1 the microphone is switched on; the dis-
tance between microphone and receiver is
10 – 50 cm The vertical angular deviation
with respect to the ultrasonic transmitter
(symbol
ceed ±30°
−30° +30°
to

Fig. 5 Distance during REMOSET transmission
2 no menu is called up on the microphone; the
receiver is not in the setting mode
3 the symbol
the display does not flash
Transmission power (RF Power)
Use the button to set the transmission

power to Hi = high transmission power
(50 mW) for a long range, but a short
battery life or
use the button to set the transmission

power to Lo = low transmission power
(10 mW) for a long battery life, but a
short range
Automatic switch-off
when the microphone is muted, to save
the batteries
Adjustable time: 1, 10, 30 minutes and
OFF (= no automatic switch-off)
When 30, 10 or 1 are set as switch-off
time, will be shown on the display.
) of the receiver must not ex-
RU-901G3/5
(= batteries discharged) on
13