Operation; 1 Power Supply; 2 Switching The Microphone On / Off; Indications On The Display - JTS RU-G3TH/5 Mode D'emploi

4 Operation

4.1 Power supply

For power supply, two 1 5 V batteries of size AA
are required When the symbol
play flashes and the LED (2) lights up in red, the
batteries are discharged and should be replaced
•
Only insert batteries of the same type and
always replace both of them
•
If the microphone is not in use for a longer
period of time, always remove the batteries
as a precaution to prevent damage due to
battery leakage
1) To access the battery compartment (10), hold
the microphone head and screw off the screw
sleeve (4)
2) Open the battery holder (11), see fig 2 on
page 10
3) Insert the batteries with the positive and neg-
ative poles as indicated in the holder
4) Close the battery holder, then screw on the
screw sleeve
5) Instead of non-rechargeable batteries, it is
also possible to insert two rechargeable NiMH
(nickel-metal hydrate) batteries of size AA To
charge these batteries, the charging station
G3CH-2 is ideally suited: Leave the batteries
in the microphone and insert the microphone
into a charging slot Power is supplied via
the contacts (12) at the lower end of the
microphone
Never put batteries in the household
waste Always dispose of the batteries
in accordance with local regulations

4.2 Switching the microphone on / off,

indications on the display,

muting the microphone
1) To switch on the microphone, press the but-
ton (5) or briefly slide the MUTE switch (3)
down and up The LED (2) shows green and
the backlight of the display (1) lights up for a
few seconds When you press a button, the
backlight is briefly switched on again
If the LED (2) lights up in red and if the
symbol starts flashing on the display, the
batteries are discharged
12
2) The display can show the following informa-
tion:
Indication Meaning
on the dis-
Fig. 3 Information on the display
3) To briefly mute the microphone (e g in
speech or music pauses), slide the MUTE
switch to the lower position: The LED (2) will
start flashing and the symbol
on the display
play, the microphone will automatically switch
off after an adjustable time to save the batter-
ies To change the time or to deactivate the au-
tomatic switch-off function, see chapter 4 3 1
4) To switch off the microphone, keep the
button
shown on the display

4.3 Settings

The microphone RU-G3TH / 5 can be set via a
menu (fig 1) or most conveniently from the
receiver RU-901G3 / 5 by means of the REMOSET
function (chapter 4 3 2): When the settings for
RU-G3TH / 5 have been made on the receiver,
they can be transferred to the microphone by
the press of a button
4.3.1 Settings via the menu
1) Keep the button SET (7) pressed for 2 seconds
until SEtUP is briefly shown on the display
(fig 1, page 10)
Transmission power: high (50 mW)
When the microphone is muted, it will
automatically be switched off after an
adjustable time
(preset time: 10 minutes)
Microphone muted by means of the
MUTE switch (3)
Battery status
– –
full
Key lock activated
Group number (1 ... 6)
and channel number (1 ... 22)
as an alternative
transmission frequency
(506.000 ... 542.000 MHz)
When the symbol
pressed for 2 seconds until OFF is
low (10 mW)
–
discharged
will be shown
is shown on the dis-