Publicité
Les langues disponibles
Les langues disponibles
Booster pack operating Instructions
JuMp Starting
noTe: Do not store the Booster Pack below 50° F when using as a jump starter. A Booster Pack will not
be able to produce its maximum power at low temperatures.
1. Make certain the vehicle ignition switch is off before making cable connections.
2. Do not touch RED (POS +) clamp to BLACK (NEG -) clamp.
3. Use in well-ventilated area.
4. Wear safety glasses.
5. Clamp the positive (RED +) clip to the positive terminal on the weak battery (for negative system).
6. Clamp the negative (BLACK -) clip to the engine (ground). Make sure cables are not in the path of
moving belts or fan.
7. Stay clear of batteries while jump starting.
8. Start the vehicle.
9. Once the vehicle is started, disconnect the negative (-) clamp.
10. Disconnect the positive (+) clamp.
11. Return clamps to the case for safe storage.
iMportant
If the vehicle doesn't start within 6 seconds, wait three (3) minutes before attempting to start the vehicle
again. This will allow the Booster Pack battery to cool. Shortening this cooling time can cause damage to the
Booster Pack battery.
RISk of InjuRy fRom movIng PARTS.
• Never connect the Booster Pack clamps to a vehicle when the engine is running.
• Always stay clear of fan blades, fan belts, pulleys and other moving engine parts when
working near an engine. Moving engine parts can cause severe personal injury including
dismemberment.
• Always make sure that the Booster Pack cables and clamps are positioned so they
will not come in contact with any moving engine parts.
12 volt DC power supply
Your Booster Pack can also function as a mobile 12 volt DC temporary power source. noTe: for a 12 volt
device to be used with the Booster Pack, it must have a cigarette lighter-style plug or receptacle using
the Accessory Power Cord.
vehicle "Computer Memory retainer"
When a vehicle battery is replaced, or the battery cables disconnected, the memory for some vehicle
computer components may be lost. The Booster Pack can be used to eliminate this problem in some situa-
tions.
To use the Booster Pack as a memory power back-up, using the accessory power cord, plug one end of
the cord into the vehicle's cigarette lighter and the other end into the Booster Pack accessory outlet.
UsB port
Use the USB port on this unit to charge most electronics with a USB charger. Certain electronic devices
(iPod) are not compatible with your Booster Pack.
MJS1500
4
08/20/08
Publicité
