Publicité
Les langues disponibles
Les langues disponibles
Always wear eye
protection when working
on or around lead-acid
batteries.
If splashed with battery
acid:
Immediately wash effected area, such
as face and particularly the eyes, with
clean water. Continue washing area,
face and eyes until medical help arrives.
Risk of explosive gases.
Lead-acid batteries
generate hydrogen gas
during normal operation.
More gas is generated
when the battery is
charging. Hydrogen
gas is:
Charging your Booster pack
Before initial use, the battery should be charged for 12-24 hours. The green "Full Charge" LED will come
on when the battery has received a full charge.
LED Operation/Battery Status Function
When the Battery Status button is depressed, the 3 LEDs on the right hand side of the display panel will
light up, depending on the state of charge of the battery.
The Booster Pack battery voltage level is indicated by the LED's:
In addition, one of the CHARGING or CHARGE COMPLETED LED's will also illuminate, depending on the
level of charge in the Booster Pack battery. If the Booster Pack is not fully charged (at 12.2 volts or
below), the Red CHARGING LED will illuminate as an additional reminder that the Booster Pack can use
additional charging.
If the Booster Pack battery is fully charged (12.7 volts or higher), then the Blue CHARGE COMPLETED LED
will illuminate, letting you know your Booster Pack battery is at full power.
There are 2 methods of charging your Booster Pack.
Wall Charger — Plug AC charger cable into standard wall AC outlet. Plug the AC charger cable into
access point on unit (lights on front will illuminate). Charging is complete when the green full charge light
has been on for 2 hours. Your Booster Pack charger is a fully automatic charger which maintains the
charge of the battery as long as your Booster Pack remains plugged into a wall socket and that socket
has 110V power. Leaving your Booster Pack plugged into a 110V power source until needed will not dam-
age your Booster Pack battery and will ensure it always delivers a full charge.
Accessory Power Cord — Plug one end of the cord into the accessory power outlet on the Booster Pack.
Plug the other end of the cord into a 12 volt vehicle lighter outlet. Check for full charge of the Booster
Pack by looking for the green full charge light to come on.
MJS1500
1. Explosive
2. Poisonous to breathe
3. Highly flammable
To avoid an explosion and/or the
possibility of being splashed with
battery acid:
• Never allow the red and black clamps
to touch each other, nor to both touch
the same metal object.
• Only attempt to jump start a vehicle
or boat in a well ventilated area.
• Always connect the red (+) clamp to
the positive (+) battery terminal first.
• Do not connect the black (-) clamp to
the negative (-) battery terminal.
• Do connect the black (-) clamp to a
non-moving metal part on the engine.
• Never smoke or allow any sparks/
Green
>12.7V
Yellow
12.2V-12.7V
Red
<12.2V
3
flame near a battery or engine.
• Use the Booster Pack portable
power source to boost lead-acid
batteries only. Do not use unit to
boost dry cell batteries.
• Remove jewelry such as rings,
bracelets, necklaces and watches
when working around a battery. A
lead-acid battery can produce a short
circuit current which can melt metal
and result in a severe burn.
• Do not drop tools or other metal
objects on or near the battery as a
spark may result, igniting explosive
gases.
• Do not jump-start or attempt to
recharge a frozen battery.
08/20/08
Publicité
