Troubleshooting; Technical Data - BOMANN KS 7247 Mode D'emploi

through a channel, is collected in a drip tray located
on the compressor, where it will evaporate. Make
sure the water discharge opening does not get
clogged. A light formation of ice on the interior back
during operation is normal.
A permanently high-power level can lead to in-
creased ice formation. In this case, the fridge can be
→ set a lower power level.
defrosted manually
To achieve better cooling and to save energy, defrost
the freezer manually regularly as follows:
 To start the defrosting process, disconnect the
appliance from the power supply.
 Remove the food items and keep covered at a
cool location.
 When the ice has melted, wipe the condensate
away and dry the appliance interior.
 Then you may restart the appliance by connecting
the plug and turning the temperature control.
Changing the bulb
CAUTION:
Do NOT remove the cover of the interior light.
The LED light may be replaced / repaired in case of
failure / defect only by an authorized specialist.

Troubleshooting

Before you contact an authorized specialist
Problem Cause / Action
Unit is not
∙ Check the power supply / tempera-
working
ture setting / ambient temperature.
properly or
∙ Unblock the ventilation openings,
at all
install the unit freely.
Loading is
∙ Check the temperature setting /
too warm
ambient temperature. ∙ Open the
door only as long as necessary.
Problem Cause / Action
Loud noise
∙ Check the appliance position.
during op-
∙ See the section
eration
Water on
∙ Check the temperature setting /
the unit
water discharge channel or opening.
bottom
Light does
∙ Check the power supply.
not work
∙ See
NOTE:
If a problem persists after following the steps above,
contact your trader or an authorized technician.

Technical Data

Climate class N/ST: this appliance is intended to be
used at ambient temperature ranging from 16°C to
38°C.
Electrical connection............................................
Power voltage: .........................220-240 V~ / 50 Hz
Rated power: ..............................................90 W
Rated current: .............................................0.6 A
Dimension H x W x D / Weight...............................
Appliance size: ......................84.2 x 47.5 x 44.8 cm
Net weight: ..................................approx. 23.0 kg
For more information about the product, scan the QR
code on the supplied energy label and/or visit the
official website of the product data bank:
https://eprel.ec.europa.eu
The right to make technical and design modifications
during continuous product development remains
reserved.
This appliance has been tested according to all rele-
vant current CE guidelines, such as electromagnetic
compatibility and low voltage directives, and has
been constructed in accordance with the latest safety
regulations.
46
"Operating noise".
"Changing the bulb"
.