Publicité
Les langues disponibles
Les langues disponibles
• Protect the socket and plug against moisture. Use a drip loop to ensure that water cannot
reach the socket via the power cord.
• If the power cord of the pump is damaged, it can not be replaced. The pump should be
recycled. A new pump is available from your dealer.
• Be careful with the combination of water and electricity. Do not operate with wet hands. Dry
hands before carrying out maintenance.
• Always switch off all devices in the aquarium before maintenance. Disconnect the plug(s) from the socket.
• This device can be used by children aged from 8 years and above, persons with reduced physical, sensory
or mental capabilities or lack of experience and knowledge, if they have been given supervision or
instructions concerning the use of the device in a safe way and understand the hazards involved. Children
shall not play with the device. Cleaning and maintenance of the device shall not be done by children
without supervision.
• Modifications to the device may affect the safety. The warranty will also expire.
Function
Eco-Flow 120 and 240 are external filters for cold water and tropical aquariums. Suitable for aquariums with a maximum
volume of 120 and 240 litres respectively. The filters are equipped with a filter foam set for mechanical filtration, and you
can optionally add biological filter media (activated carbon, Crystal Clear or CrystalMax).
Installation
• Rinse filter and all parts with clean tap water to remove any dirt and residues.
Fig. A Open the filter, lift the four handles. Make sure that all four handles are in the outward position and free from the
hinges.
• Remove the grids and filter foam from the filter and rinse them clean.
• If you want to add biological filter media, place it in a filter bag at the bottom of the filter.
Fig. B Place the bottom grid correctly into the filter, then place the filter foam-set in the correct order (first white filter
wool, next the black sponge, followed by the yellow sponge and the blue sponge) now place the top grid, so there
is space between the lid and the foam set.
Fig. C Install the outlet U-pipe (g) and either the spray bar (i) or the jet spray (h) in the aquarium.
• Install the Inlet tube(f) make sure it has the desired height.
Fig. D Turn the inlet connector (a) on the filter cover and make sure the valve is closed.
Fig. E Connect a hose between the inlet pipe (f), secure the hose with the hose clamp and the inlet connector (a) of the
filter, secure the hose with the nut on the connector.
• Connect a hose to the outlet of the filter pump (d) and secure the hose with the nut on the pump.
• Fill the filter with clean tap water up to the top.
• Close the filter and make sure that the rubber seal in the lid is in the right position. Place the handles correctly on
the lid edge and click into place.
• Check all connections to avoid leakage!
• Open the valve on the inlet connector.
Fig. F Suck the outlet hose fitted to the pump until it is completely filled with aquarium water.
• Close the valve.
• Connect the outlet hose to the Outlet U-Bar (g) (secure the hose with the hose clamp).
• Open the valve and plug the pump into mains, the filter will start working and the water will circulate.
5
Publicité
