Timer Function - Becker Centronic VarioControl VC180-II Notice De Montage Et D'utilisation

Overwriting the master
Put the radio socket into programming mode.
There are several ways of putting the radio socket into programming mode.
• By switching on the power
• With the programming button
Putting the radio socket into programming mode by switching on the
power
Pull the radio socket out of the mains socket and plug it back into the 230 V
mains socket nearest the consumer after approx. 5 seconds.
▻ The radio socket goes into programming mode for 3 minutes (LED
flashes).
Putting the radio socket into programming mode with the programming
button
Press the programming button on the radio socket until the LED starts to flash.
▻ The radio socket goes into programming mode for 3 minutes (LED
flashes).
Overwriting the master transmitter
Press the programming button of the new master transmitter for 10 seconds.
▻ The radio socket confirms.
► The new master transmitter has now been programmed and the old mas-
ter transmitter overwritten.
The radio socket lists the switching times of the Centronic transmitter timers
with display.
The central command must be programmed separately in the radio socket so
that the time switching commands can be executed.
22 - en

Timer function