Becker Centronic VarioControl VC180-II Notice De Montage Et D'utilisation page 20

Programming the master transmitter
When in programming mode, press the transmitter's programming button until
the LED on the radio socket confirms programming.
► Programming is now complete.
The consumer can now be operated as described in the chapter "Operation".
Programming additional transmitters
In addition to the master transmitter, up to 15 further trans-
mitters can be programmed in the radio socket.
Put the radio socket into programming mode.
Press the programmed master transmitter's programming button for 3
seconds.
▻ The radio socket goes into programming mode for 3 minutes (LED
flashes).
When in programming mode, press the programming button of a new trans-
mitter which has not yet been programmed in the radio socket for 3 seconds.
▻ The radio socket confirms.
Now re-press the programming button of the new transmitter you wish to pro-
gram for 3 seconds.
▻ The radio socket confirms.
► The new transmitter has now been programmed.
20 - en