Publicité
Les langues disponibles
Les langues disponibles
K E 6 4 0 E S | K E 6 4 0 V A R I O
9.1.6 Insert the new built-in grinder into the casing.
Check for the correct position of the flat spring
in the built-in grinder's spout. It has to extend
into the spout instead of laying on top of the
spout tube.
9.1.7 Connect the motor plug with the grinder and store the con-
nection well in the rear of the casing.
9.1.8 The cover of the built-in grinder is marked with two red
lines:
Red Mark 1:
Basic adjustment 0, finest setting and minimum
grinding disc spacing.
Red Mark 2:
Basic factory setting and also the position for instal-
ling and removing the lid, in order to achieve the factory setting
after positioning the lid.
Red Mark 1
EN
Therefore turn the grind adjustment of the built-in grinder to the
right red mark 2 for refitting the grinder's lid.
9.1.9 Replace the grinder's lid on the grinder and adjust to the
desired fineness.
Red Mark 2
9.1.10 Carefully lay the grinder on its side. Reassemble the three
screws under the base plate. Reposition the grinder on its rubber
feet.
Note the correct position when lowering the lid
onto the grinder. The detent screws have to fit
into the gaps. Otherwise the basic adjustment
is lost and espresso grinding is not possible any-
more.
1 7
Publicité
Chapitres
