DITTING KE640 ES Mode D'emploi page 10

K E 6 4 0 E S | K E 6 4 0 V A R I O
6.1.1 Actuate the main switch on the rear of the grinder (pos. 19).
6.1.2 Open the hopper. Pour whole roasted espresso beans into
the hopper from above. Never pour in coffee powder. Close the
hopper.
6.1.3 Check whether the hopper slide (pos.18) is open.
6.1.4 Choose the pre-selection button for a single or double shot
of espresso (pos. 8+10).
6.1.5 Push the portafilter of your espresso machine into the rest.
Grinding starts and ends automatically.
6.1.6 Break function: If you pull out the portafilter while grind-
ing the process will be interrupted. The LED of the active pre-se-
lection button blinks. The process can be continued by pushing
the portafilter back onto the start-button. The saved, missing
amount will be ground.
For stopping the grinder and deleting the remaining time simply
push the blinking pre-selection button. The entire set grinding
quantity or grinding time is available once again.
6.2 Grind adjustment (grinding fineness)
Adjust the grinding fineness by pulling the sliding detent out
to the front* and turning the lid / grinding fineness adjust-
ment to the mark 2.
Note that "0" is the finest setting and "10" is the coarsest set-
ting.
*respectively for KE640 Vario: loosen the adjustment screw and refasten it after the adjustment
Rotation to the left
Rotation to the right = coarse
fine
pull
= fine
coarse
1 0