JB Systems DSP12 Mode D'emploi page 2

ENGLISH
OPERATION MANUAL
Thank you for buying this JB Systems product. To take full advantage of all
possibilities, please read these operating instructions very carefully.
FEATURES
• 12 channel modular Dimmer + Switch pack
• Max load 10A per channel with automatic 10A circuit breakers
• DMX and analog 0/10V inputs
• Block or individual channel addressing (soft patch)
• General or individual channel curve selection: switch, linear or square curve
• General or individual channel presets 0-100% (no control panel needed)
• General or individual channel preheats 0-50%
• DMX-failure: auto DMX-hold, auto analog 0/10V or auto built-in patterns
• Completely modular setup: very service friendly!
• Phase Correction for perfect, linear dimming curves
• LCD display with channel output indications
• Menu driven setup
• 3-Phase and single phase 230Vac 50~60Hz inputs
• Power failure memory
BEFORE USE
Check the contents:
Check that the carton contains the following items:
• DSP12 dimmer/switch pack
• Operating instructions
JB SYSTEMS®
OPERATION MANUAL
1/40 DSP12
ENGLISH
CAUTIONS REGARDING HANDLING
SAFETY INSTRUCTIONS:
CAUTION: To reduce the risk of electric shock,
CAUTION
do not remove the top cover. No user-
serviceable parts inside. Refer servicing to
qualified service personnel only.
The lightning flash with arrowhead symbol within the equilateral triangle is
intended to alert the use or the presence of un-insulated "dangerous voltage"
within the product's enclosure that may be of sufficient magnitude to
constitute a risk of electric shock.
The exclamation point within the equilateral triangle is intended to alert the
user to the presence of important operation and maintenance (servicing)
instructions in the literature accompanying this appliance.
To prevent fire or shock hazard, do not expose this appliance to rain or moisture.
Do not place metal objects or spill liquid inside the unit. Electric shock or malfunction
may result.
INSTALLATION GUIDELINES:
• Placing and using the unit for long periods near heat-generating sources such as
amplifiers, spotlights, etc. will affect its performance and may even damage the unit.
• Take care to minimize shocks and vibrations during transport.
• When installed in a booth or flight case, please make sure to have good ventilation
to improve heat evacuation of the unit.
• To avoid condensation to be formed inside, allow the unit to adapt to the surrounding
temperatures when bringing it into a warm room after transport. Condense
sometimes prevents the unit from working at full performance.
• Choose the place where you put your installation very carefully. Avoid presence of
heat sources. Avoid places with vibrations or places that are dusty and humid.
• To prevent fire or shock hazard, do not expose this appliance to rain or moisture.
• In order to prevent electric shock, do not open the top cover. If a problem occurs,
contact your dealer.
• Do not place metal objects or spill liquid inside the unit. Electric shock or malfunction
may result.
• This unit may cause interference to radio and television reception.
• Very important: this product must be earthed!
MAINTENANCE
Clean by wiping with a polished cloth slightly dipped with water. Avoid getting water
inside the unit. Do not use volatile liquids such as benzene or thinner which will
damage the unit.
JB SYSTEMS®
OPERATION MANUAL
2/40 DSP12