Remise en place du ventilateur
du processeur
AVERTISSEMENT : Avant d'ouvrir votre ordinateur, prenez connaissance
des consignes de sécurité fournies et suivez les instructions indiquées à la
section
Avant une intervention à l'intérieur de
intervention à l'intérieur de l'ordinateur, suivez les instructions indiquées à la
section
Après une intervention à l'intérieur de
d'autres bonnes pratiques en matière de sécurité à la page d'accueil du site
Regulatory Compliance (Conformité à la réglementation), à l'adresse
www.dell.com/regulatory_compliance.
Procedure
1
Align the screw holes on the processor fan with the screw holes on the heat
sink.
2
Replace the four screws (M6xL10) that secure the processor fan to the heat
sink.
3
Connect the processor-fan cable to the system board.
4
Rotate the side-chassis towards the computer until it snaps into place.
Post-requisites
1
Replace the
front
2
Replace the
computer
bezel.
cover.
l'ordinateur. Après une
l'ordinateur. Vous trouverez
61