Guided Tour - Front Panel - Hartke GT100 Manuel De L'utilisateur

Guided Tour - Front Panel

1. INPUT - Connect your guitar to this standard 1/4" unbalanced jack. This GT Series Input was
designed to handle the signals from guitar with a wide range of output levels from lipstick
singe coils to the beefiest humbucker.
2. CRUNCH LED – When this light is illuminated, CRUNCH is on.
3. CRUNCH – CHANNEL 1's pre-amp level control used to dial up tube overdrive tone for just
a touch of harmonic warmth for blues all the way to a dirty rhythm of classic and modern
rock. The CRUNCH control can be switched on and off using the included footswitch.
4. VOLUME - (CH1) This is the overall volume control for CHANNEL1.
5. BASS - This control provides approximately 15 db of cut or boost at 100 Hz, with a peak
(bell) curve. When the knob is at the 12 o'clock ("5") position, there is no boost or attenu-
ation (that is, flat response). As it is turned clockwise from the "5" position, the frequency
area is boosted; as it is turned counterclockwise from the "5" position, the frequency area is
attenuated.
6. TREBLE - This peaking control provides approximately 15 db of cut or boost at 5 kHz. When
the knob is at the 12 o'clock ("5") position, there is no boost or attenuation (that is, flat
response). As it is turned clockwise from the "5" position, the frequency area is boosted; as
it is turned counterclockwise from the "5" position, the frequency area is attenuated.
7. CH1 LED – When this light is illuminated, CHANNEL 1 is selected.
8. CHANNEL SWITCH - This switch allows you to select either CHANNEL 1 or CHANNEL 2.
9. CH2 LED - When this light is illuminated, CHANNEL 2 is selected.
10. GAIN - CHANNEL 2's pre-amp level control used to dial up tube overdrive tone for classic
metal distortion, shredding leads and fat modern chunk.
11. VOLUME (CH2) - This is the overall volume control for CHANNEL 2.
4 4