STAMOS S-WECA-1 Manuel D'utilisation page 7

2.5. MIDDLE PLATE SHELF:
Align the holes of the middle plate to the holes in the left & right support rails and
the back vertical support panel.
From the outside of the left / right support rails, insert a bolt through each of the
holes and secure with a nut on the inside.
Align the 2 rear holes of the middle plate shelf with those of the back vertical
support panel, insert a bolt through each of the holes and secure with a nut on the
inside. Repeat the above on other side. Hand tighten bolts and nuts.
2.6. TOP PLATE SHELF:
Align the holes of the top shelf plate with those of the left / right support rails and
the back vertical support panel.
From outside of the left / right support rails insert a bolt through each hole and
secure with a nut.
Repeat the above for all holes.
Hand tighten bolts and nuts.
Rev. 03.03.2017
EN
12
2.7. EASY PULL HANDLE:
Align the holes of the handle with the holes on the top plate shelf.
From the outside of the shelf insert the longer bolts through each hole and secure
with nut.
Repeat the above for all holes.
Hand tighten bolts and nuts.
2.8. SAFETY CHAINS AND CYLINDER STATIONS:
Align the holes of the cylinder stations to the holes in the back vertical support panel.
From outside the stations, insert a bolt through each hole and secure with a nut.
Repeat the above for all holes.
Hand tighten bolts and nuts.
Insert the safety chains into the keyholes cut into the stations.
13 13
EN
Rev. 03.03.2017