Publicité
Les langues disponibles
Les langues disponibles
24.
The device has been designed to be used with
a cleaning agent supplied or recommended by the
manufacturer. Use of other cleaning agents may be
detrimental for safe use.
25.
Disconnect the plug from the socket when adjusting
or carrying out maintenance works on the device.
26.
If working with the device outside, make sure to use
an extension lead suitable for external use.
27.
If using an extension lead, the plug and socket have
to be watertight.
28.
The extension lead socket should be at least 60 cm
above ground.
29.
Avoid unintentional starting. Don't carry a pluggedin
tool with finger on switch. Be sure the tool is
switched off when plugging it in.
30.
Do not move the device by pulling on the high-
pressure hose. Use the transport handle on top of
the device.
31.
To ensure the designed operational integrity of
power tools, do not remove installed covers or
screws
32.
Do not wipe plastic parts with solvent. Solvents such
as gasoline, thinner, benzene, alcohol, ammonia and
oil may damage and crack plastic parts. Do not wipe
them with such solvents. Wipe plastic parts with
a soft cloth lightly dampened with soapy water.
33.
For safety reasons use only original spare parts.
34.
If any device elements such as high-pressure hoses
or nozzle are damaged, cease using the devoice
immediately.
35.
Check damaged parts. Before further use of the
tool, any part of the casing or other parts that are
damaged should be carefully checked to determine
that they will operate properly and perform their
intended function. Check for alignment of moving
parts, mounting, and any other conditions that may
affect its operation. A part that is damaged should
be properly repaired or replaced by an authorized
service centre unless otherwise indicated elsewhere
in this instruction manual. Defective switches should
be replaced by an authorized service centre. Do not
use the tool if the switch does not turn it on and off.
36.
A switched on device should not be left unattended.
37.
Keep all tools in good condition. Keep the tools
clean for better and safer performance. Follow
the instructions for lubricating and renewing the
accessories. Inspect extension cords periodically and
replace if damaged. Keep handles dry, clean, and free
from oil and grease.
38.
The device is designed for exterior use.
39.
Some cleaning agents may be hazardous if inhaled
or swallowed. In the event of a risk of inhaling
hazardous substances, use an appropriate face mask.
40.
If using the device in low ambient temperatures,
inspect all device parts for ice. Do not store the
device in temperatures below 0°C.
41.
Do not disconnect the high-pressure hose from the
device and spray gun if the device is pressurized. This
may cause injury.
42.
Make sure water used for pressure cleaning is free
from contaminants, sand and corrosive chemical
substances. This might reduce the lifetime of the
pressure washer.
43.
Attention! Of used incorrectly the high-pressure
water stream may damage the washed surface.
10
EN
Always test the water stream in an open space or on
another surface which is similar to the surface to be
washed.
44.
Do not use flammable cleaning agents – risk of
explosion
Failure
to
follow
instructions may result in serious injuries or death!
TECHNICAL DATA
Product name
Model
Rated voltage [V~]/
Frequency [Hz]
Power [W]
Protection class
IP protection class
Working pressure
[bar]
Maximum working
pressure [bar]
Flow rate [l/min]
Max. feed pressure
[MPa]
Max. water
temperature [°C]
Soung pressure
level L
pA
Sound power
level L
WA
Vibration emission
value
Dimensions [mm]
Weight [kg]
SCOPE OF APPLICATION
The pressure washer is designed for washing different
surfaces using a high-pressure water stream.
The user is liable for any damage resulting from non-
intended use of the device!
BERORE THE FIRST USE
Upon receipt of the goods, check the packaging for
integrity and open it. If the packaging is damaged, please
contact your transport company and distributor within 3
days, and document the damages as detailed as possible.
Do not turn the package upside down! When transporting
the package, please ensure that it is kept horizontal and
stable.
safety
recommendations
Pressure washer
1400W
2200W
HT-HUDSON
HT-HUDSON
1400B
2200
230/50
1400
2200
II
IPX5
80
120
110
150
6,5
7,5
1,2
50
81 dB (A)
78 dB (A)
Uncertainty
Uncertainty
K=3dB(A)
K=3dB(A)
92 dB(A)
89 dB (A)
Uncertainty
Uncertainty
K=3dB(A)
K=3dB(A)
≤ 2,5 m/s
2
Uncertainty K=1,5 m/s
2
260x315x430
345x432x875
5,5
12
16.04.2020
and
Publicité
