Publicité
Les langues disponibles
Les langues disponibles
Website Egardia
www.egardia.com
INSTALLATION GUIDE SMOKE DETECTOR
Congratulations on the purchase of your Egardia smoke detector.
Customer Service
Please visit
www.egardia.com
if you would like further information about the installation and use of
Egardia. The answers to a number of frequently asked questions can be found at
www.egardia.com/userquestions.
This package has been put together with care. Please contact our customer service if you would like
any help during installation or if something is missing from the package. Never return a package
without prior instruction from our customer service.
Smoke detector
The optical smoke detector uses a concentrated light beam to detect the presence of smoke
particles in the air. During the initialization process the smoke detector's sensor takes various
readings of the surrounding environment and memorizes the results. After initialization, the sensor
continually takes readings and any significant rise in the amount of particles will trigger an alarm.
OVERVIEW SMOKE DETECTOR
1.
Status indicator – Shows the status of the smoke detector.
2.
Register button – The register button is used for the following:
a.
To take readings of the surrounding environment.
b.
To test the connection between the smoke detector and the gateway.
c.
To test correct functioning of the smoke detector.
d.
To silence the local alarm signal.
3.
Battery compartment – Holds the batteries.
4.
Mounting holes – Holes for the mounting plate.
5.
Mounting plate – To mount the smoke detector using screws.
6.
Mounting clips – Part of the mounting plate to secure the plate into the mounting holes.
In appendix 1 you will find a drilling template to determine hole positions.
Smoke detection
When the smoke detector detects smoke the status indicator will lit red to indicate that a smoke
alarm signal is being sent to the gateway. The gateway emits an interrupted sound:
3 beeps - pause - 3 beeps. The smoke detector also sounds a local alarm. The internal siren of the
smoke detector sounds and the status indicator will rapidly flash red for 10 seconds. After this local
alarm of 10 seconds the smoke detector will carry out another reading. When the smoke detector
still detects smoke it will trigger another local alarm. The smoke detector will repeat to signal until no
more smoke is detected. The local alarm of the smoke detector will automatically switch off.
Local silent alarm
In the case that the smoke detector is sounding a local alarm the internal siren of the smoke
detector may be switched off for 10 minutes. Press the register button of the smoke detector to
silence the alarm. During the 10-minute period the status indicator of the smoke detector will flash
once per second. After 10 minutes the smoke detector will beep twice to indicate returning to normal
operation. Should the smoke detector still detect smoke then the local alarm will sound again.
1
Publicité
