Haussmann 5959003 Guide D'utilisation page 17

Setting the Torque
The required torque can be preselected in 20 settings with
the torque preselection ring (3). With the correct setting, the
insert bit is stopped as soon as the screw is screwed flush
into the material or when the set torque is reached.
Select a higher setting when driving out screws, or set to
the symbol "Drilling".
The safety clutch is deactivated in the "Drilling" position.
Gear Selection, Mechanical
Actuate the gear selector (4) only when the tool is
at a standstill.
Two speed ranges can be used with the gear selector (4).
Gear 1:
Low speed range (0-400 RPM); for screwdriving or
working with a large drilling diameter.
Gear 2:
High speed range (0-1300 RPM); for working with a small
drilling diameter. If the gear selector (4) cannot be fully
engaged, lightly rotate the driver spindle with the drill bit
by twisting the drill chuck.
LED
Continuous lighting 3 x green
Continuous lighting 2 x green
Continuous lighting 1 x green
Slow flashing 1 x green
Capacity
≥66%
34-66%
11-33%
≤11%
17
The 3 LEDs of the battery charge-control indicator (9) flash
rapidly when the battery temperature is not within the
operating temperature range of -10º to +70
158ºF).
Temperature Dependent Overload Protection
When used as directed, the power tool cannot be subject
to overload. When the load is too high or the allowable
battery temperature of 70
electronic control switches off the power tool until the
temperature is in the optimum temperature range again.
The 3 LEDs of the battery charge-control indicator (9)
flash rapidly when the battery temperature is not within
the operting temperature range of -10 to +70
158ºF) and/or when the overload protection has actuated.
Protection Against Deep Discharging
The Li-ion battery is protected against deep discharging
by the "Electronic Cell Protection (ECP)". When the battery
is empty, the tool is switched off by a protective circuit:
the inserted bit no longer rotates.
Operating Instructions
Apply the power tool to the screw only when it is switched
off. Rotating tool inserts can slip off.
Soft Grip
The gripping surface (soft grip) (5) reduces the danger of
slipping and thereby improves the grip and handling of
the tool.
At the same time, the rubber coating provides a
vibration-reducing effect for increased comfort for the
operator.
Tips
After longer periods of working at low speed, allow the
drill to cool down by running it for approx. 3 minutes at
maximum speed with no load.
For drilling in metal, use only perfectly sharpened HSS
(high-speed steel) drill bits.
Before screwing larger, longer screws into hard materials,
it is advisable to predrill a pilot hole with the core diameter
of the thread to approx. 2/3 of the screw length.
Cleaning and Maintenance

CAUTION!
!
Place the direction of rotation direction switch (7) into the
middle position before carrying out any tasks on the tool,
e.g. changing bits or maintenance, or before transporting
or storing the tool. Accidental operation of the On/Off
switch (8) may result in injury.
Always pull the battery charger (12) out of the mains
socket and remove the battery pack before you clean or
maintain the device.
The cordless drill/driver is maintenance-free.
1) Always keep the tool clean, dry and free of oil or
grease.
O C (14ºF to
O C (158ºF) is exceeded, the
O C (14ºF to