Functions Of The Multispectral Sensor Button; Disconnect The Multispectral; Led Properties - Parrot Sequoia Guide De Démarrage Rapide

3. Turn the drone on the Y-axis (pitch axis) (Diagram F) until the
multispectral sensor indicator light flashes blue.
4. Turn the drone on the X-axis (pitch axis) (Diagram G) until the
multispectral sensor indicator light changes colour.
Note: Once the calibration is complete the colour of the
multispectral sensor light varies depending on Sequoia's status.
For example, if the multispectral sensor memory is full, the indica-
tor light will flash yellow.
6
Diagram E
Diagram F
Diagram G

Functions of the multispectral sensor button

Use the button to enable/disable burst mode, take photos and enable/
disable Wi-Fi on Sequoia.
Note: Sequoia must be turned on to activate these features.
1 click Take a photo
2 clicks Enable/disable shots
4 clicks Enable/disable Wi-Fi
Hold down (3 seconds) Switch off Sequoia

Disconnect the multispectral

Press and hold the Sequoia button for 3 seconds to turn it off. The
indicator light goes out. If you disconnect Sequoia while the indicator is
still on the latest photos may be corrupted.

LED properties

Multispectral sensor
Start up
When you turn on Sequoia the LED has the following properties:
The sensor is ready to take a
photo.
The sensor needs to be
calibrated.
Other
LED properties
Quick flashing orange Shutting down
Slow flashing orange Update in progress
Flashing blue Enabling/Disabling Wi-Fi
Problem
Flashing red Hardware malfunction
Meaning
7