Elektrotechnik Schabus SHT 240 Notice D'utilisation page 6

INSTALLATION INSTRUCTION
Warning: Do not use the device outside!
Sensor installation
The sensor reacts to water contact at
the two metal contacts.
The assembly height of the sensor
defines, at what level the water detec-
tor will sound an alarm.
For quick warning in case of water
ingress, you mount the sensor close
to the floor, so both sensor contacts
touch the ground.
For installing the sensor use the
provided assembly material.
STARTUP
The SHT 240 water detector just has to be plugged into the socket (230 V AC / 50-60 Hz).The
LED (Function) lights up green and signals that the device is ready for use.
ALARM
As soon as the sensor has contact with water, an acoustic and an optic alarm signal sounds.
The LED lights up red. When the water level sinks, the alarm is switched off.
FUNCTION TEST
Function test of the device: touch both sensor contacts with a waterlogged cloth or an electric
conductive metal and the alarm is set off immediately. When you remove the cloth or the
metal, the alarm is switched off.
For your safety, we recommend that you carry out this test constantly!
GENERAL
Elektrotechnik Schabus GmbH & Co. KG is not liable for damages and/or losses of any kind
such as individual damages or consequential damages brought about by the water detector
not issuing an alarm despite any changes in water conditions.
CLEANING AND CARE
Avoid the effects of moisture (spray or rain water), dust as well as direct insolation on the
device. Clean the device exclusively with a dry linen cloth; in case of heavy dirt accumulation,
it may be slightly moistened. Do not use any detergents containing solvents.
6
GAS ALARM
Sensor