Before Use; General Safety Instructions - Vermeiren SE09 Manuel D'utilisation

EN
NL
2

Before use

WARNING
 Do NOT install, maintain or use this product unless you have read and fully understood all
instructions in this manual and all relevant manuals regarding the wheelchair equipped with
this product.
 Do not try to open or disassemble the console in any case - there are no user-serviceable parts
inside.
 In case of doubts or questions, do not hesitate to contact your local specialist dealer, your care
provider, or your technical adviser to help you with this.
Vermeiren is responsible for software updates/repairs. For adaptations in the software
contact Vermeiren, see our website
2.1

General safety instructions

Keep the following general warnings in mind during use:

The operating consoles have been tested for electromagnetic compatibility on typical,
representative
EN 12184: 2014, ISO7176-21: 2009. Nevertheless, sources of electromagnetic field may
influence the driving performance of your wheelchair, like the fields of mobile phones, power
generators or high-power energy sources. On the other hand, the electronics of your
wheelchair can affect other electronic appliances too, like alarm systems of shops and
automatic doors. We therefore advise you to check your operating console / wheelchair
regularly for damage and wear, since these may enlarge the interference.

Be aware that the surface of the operating console may get very hot due to solar radiation or
heating devices. Be careful when touching.

Make sure that the controller does not become colder or hotter than the allowed minimum
and maximum temperature, see the wheelchair user manual.

Before switching the wheelchair on, be aware of your environment/situation. Adjust your
speed accordingly before driving off. We advise you to use the slowest speed setting to drive
indoors. For outdoor driving you can adjust the speed to a suitable speed at which you feel
comfortable and safe.

Do not touch the connector pins. If you touch the pins, they can become dirty, or they can be
damaged by electrostatic discharge.

Immediately turn the controller off and consult your service agent if the vehicle:
is damaged;
o
does not behave the same every time;
o
does not respond normally, the way you expect it to;
o
becomes hotter than normal;
o
smokes;
o
does not change its speed when you adjust the speed dial;
o
displays a fault on its fault indicator and the controller does not perform normally.
o

Turn the controller off:
when you do not use it;
o
before you get in or out of the wheelchair;
o
if your vehicle drives by itself or against your will. When you turn the controller off, the
o
vehicle will halt.
Risk of injuries and damage
http://www.vermeiren.com/
vehicles and comply with the appropriate
4
SE09
2022-01
Before use
EMC standards: