What To Do If You See The Following Symbols On The Display - Electrolux ECG6200 Mode D'emploi

822_949_387 ECG6200_Elux.book Seite 104 Sonntag, 27. Januar 2008 11:07 23
g
0 Empty the water tank, fill the tank
with at least 1 liter of water and add
the descaling agent.
1 Note: Make sure descaling agent is
splashed onto surfaces sensitive to acid
such as marble, limestone and
ceramics.
0 Place a container with a minimum
capacity of 1.5 litres under the steam
nozzle (Fig. 9).
0 Turn the knob for steam and hot water
to the position
The descaling program starts and the
descaling solution runs out of the
steam nozzle. The symbols
"P" are steady on.
The descaling programme automati-
cally performs a series of flushes and
pauses to remove limescale deposits
from inside the coffee maker.
After approx. 30 minutes, the water
tank will be empty and the symbols
and are flashing and "P" is steady
on.
0 Turn the knob for steam and hot water
back to the position
The machine is now ready to be rinsed
with fresh water.
0 Remove the water tank and fill it with
fresh water and then replace it in the
appliance.
0 Empty the container under the steam
nozzle and replace it there.
0 Turn the knob for steam and hot water
to the position
A rinsing procedure with fresh water is
carried out and the rinse water runs
out of the steam nozzle. The symbols
, and "P" are steady on.
After a few minutes, the water tank
will be empty and the symbols
are flashing and "P" is steady on.
0 Turn the knob for steam and hot water
back to the position
The symbols as for the last coffee mode
selected are shown, and the symbol
is steady on.
104
0 Empty the container with rinsing
0 Remove water tank, fill it with fresh
3
.
14
, and
• The water tank is empty or is posi-
0 Fill the water tank, as described in sec-
• The tank is dirty or encrusted with
0 Rinse or descale the water tank.
.
• The appliance cannot make coffee.
0 Place a container under the steam noz-
• The coffee runs off too slowly.
0 Turn the knob for setting grinding tex-
.
• The waste coffee container is full.
0 Empty the waste coffee container and
and
.
water.
water and replace it.
The machine is now ready for use and
its status is as for the last coffee mode
selected.
After running the descaling program,
you are advised to throw away the first
cup of coffee from the machine.
What to do if you see the
following symbols on the
display ...
The symbol is on steady
tioned incorrectly.
tion „Filling with water", page 93, and
insert it fully.
limescale.
The symbols and are flashing
zle and turn the knob for steam and
hot water anticlockwise to the position
(Fig. 9).
ture (Fig. 12) one click clockwise whilst
the grinder is grinding beans for the
preparation of next coffee (see „Set-
ting the grinding texture", page 100).
The symbol is on steady
clean it as described in the section
„Emptying the waste coffee container",
page 102, then replace it.