Hazet 9033-5 Mode D'emploi page 18

Mini Orbital Sander:
• Press the abrasive paper onto the
disc. Ensure the paper's and the disc's
perforation correspond to each other.
Check tight fit of abrasive paper.
• When working with the mini orbital sander,
please take care that it is only slightly
pressed to the surface to be sanded!
• Changing the grinding disc:
Loosen the plastic suction cover and tighten
the spindle to the hexagon by using the
delivered wrench. Unscrew the grinding disc
counter-clockwise. Put the new grinding
disc onto the spindle and tighten it sturdily
clockwise.
Polisher:
• Select tool according to the work to be
carried out.
• Check compressed air pressure and
if necessary adjust it according to the
working pressure indicated in the table on
page 16.
5. Maintenance and Cleaning
Oiling:
• Pneumatic tools have to be oiled throughout
their whole serviceable life. The motor and
the (ball) bearings need compressed air to
power the tool. As the moisture in the com-
pressed air leads to rust of the motor, daily
oiling of the motor is necessary. For this, the
use of an integrated oiler is recommended.
• HAZET 9070­1 Oiler can be fixed directly to
the pneumatic tool.
Oiling the pneumatic motor manually:
• Disconnect tool from the air supply and
hold with the air inlet showing upwards.
Push button and put 1 or 2 drops of special
pneumatic oil into the air inlet.
• Connect the tool to the air supply; cover
the air exit of the tool with a towel and
operate a few seconds.
• Never use combustible or easily evaporable
liquids, e.g. kerosene, petrol, diesel, etc. to
lubricate the tool.
Always wear personal protective clothing and safety equipment!
18
c
Design and Function
AttEntIOn!
cAutIOn!
Maintenance:
• Before executing any maintenance work,
• If the tool is used daily, there should be
• All damaged or worn parts, such as
• Only use spare parts recommended by the
• When disposing of components, lubricants,
• Do not use solvents or acids, esters (organic
• For after sales service please contact your
6. Trouble Shooting
In case of malfunctions, please check:
• The compressor installation and air hoses
• The compressed air in regard to the
• Whether the air motor is oiled too much.
Excess oil in the motor will be
exhausted immediately through the
air exhaust.
Never point the air exhaust at any per-
son or at any object. The air exhaust is
at the rear side of the handle.
disconnect the appliance from the air
supply.
carried out an inspection after every three
month at the latest however after every
1,000 operating hours.
O-rings, bearings etc. must be replaced. All
moving parts must be oiled.
manufacturer, otherwise the warranty will be
void.
etc. please take care that the valid regu-
lations for environmental protection are
observed.
compounds of acids and alcohol), acetone
(ketone), chlorinated hydrocarbons or nitro-
carbonic oils to clean the tool. Do not use
chemicals with a low flashing point.
distributor/retailer.
(check whether the air consumption l/min
and the hose diameter correspond to the
technical specifications of the appliance);
occurence of dust, condensate and rust
particles;