Publicité
Les langues disponibles
Les langues disponibles
2. Installation and Operating Instruction
2.1 Unpacking & Inspection
Examine the packing carton for damage upon receipt. Once the UPS has been removed from its shipping container,
everything inside the package should be inspected for damage that may have occurred while in transit. Notify the
carrier immediately if any damage is observed.
The box should include the following:
1 UPS
1 European input cable + 1 UK input cable
2 output cables (IEC320)
1 User's Manual
1 RJ11 telephone cable
Retain the packing for future use or dispose of it properly.
2.2 Overview
Front Panel
1. Utility LED
2. Fault LED
3. On Switch
4. Off Switch
5. Battery Replacement LED
6. Battery Backup LED
7. N/A
8. Battery Low
9. Bypass
10. Utility Low, UPS Boost
11. Utility High, UPS Buck
12. UPS Output Indicator
13. Polarity Error or Ground Fault
14. Overload
15. Load/Battery Level (%)
16. Load/Battery Level Indication control button
2.3 Installation
Before installation, please read carefully the following instructions:
Placement
The UPS must be installed in a protected environment away from heat emitting appliances such as a radiator or
heater. Do not install this product where excessive moisture is present.
Ventilation
The location should provide adequate air flow around the UPS with one inch minimum clearance on all sides for
proper ventilation.
Charge the Battery
A new UPS may be used immediately upon receipt. However charge loss may occur during shipping and storage.
So charging the battery for at least 8 hours is recommended to insure that the battery is fully charged. To
recharge the battery, simply leave the unit plugged into an AC outlet (This UPS will recharge in both the On and
the Off status).
1 RJ45 Network cable
1 USB communication cable
1 RS232 communication cable
1 UPSILON 2000 software CD
Rear panel
1. RJ11/RJ45 Port
2. DIP Switch
3. USB Communication Port
4. RS232 Communication Port
5. N/A
6. Input Breaker
7. Output sockets (Outlet)
8. Rating Label
9. Output breaker
10. Input socket (Inlet)
11.external batteries connector
12. SNMP slot
21
Publicité
