Batavia FLIPOUT BT-TS001 Mode D'emploi page 12

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

.
English
A moment of inattention while operating
power tools may result in serious personal
injury.
b.
Use safety equipment. Always wear eye
protection.
Safety equipment such as dust mask,
non-skid safety shoes, hard hat, or hear-
ing protection used for appropriate condi-
tions will reduce personal injuries.
c.
Avoid accidental starting. Ensure the
switch is in the off position before plug‑
ging in.
Carrying power tools with your finger on
the switch or plugging in power tools that
have the switch on invites accidents.
d. Remove any adjusting key or wrench
before turning the power tool on.
A wrench or a key left attached to a rotat-
ing part of the power tool may result in
personal injury.
e.
Do not overreach. Keep proper footing
and balance at all times.
This enables better control of the power
tool in unexpected situations.
f.
Dress properly. Do not wear loose
clothing or jewellery. Keep your hair,
clothing and gloves away from moving
parts.
Loose clothes, jewellery or long hair can
be caught in moving parts.
g.
If devices are provided for the connec‑
tion of dust extraction and collection
facilities, ensure these are connected
and properly used.
The use of these pieces of equipment
reduce hazards caused by dust.
4.
Power tool use and care
a.
Do not force the power tool. Use the
correct power tool for your application.
The correct power tool will do the job
better and safer at the rate for which it was
designed.
b.
Do not use the power tool if the switch
does not turn it on and off.
Any power tool that cannot be controlled
with the switch is dangerous and must be
repaired.
c.
Disconnect the plug from the power
source before making any adjustments,
12
7062267_FlipOut_Ma_#1503-12.indb 12
changing accessories, or storing power
tools.
Such preventive safety measures reduce
the risk of starting the power tool
accidentally.
d. Store idle power tools out of the reach
of children and do not allow persons
unfamiliar with the power tool or these
instructions to operate the power tool.
Power tools are dangerous in the hands of
untrained users.
e.
Maintain power tools. Check for mis‑
alignment or binding of moving parts,
breakage of parts and any other condi‑
tion that may affect the power tools
operation. If damaged, have the power
tool repaired before use.
Many accidents are caused by poorly
maintained power tools.
f.
Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to bind
and are easier to control.
g.
Use the power tool, accessories and
tool bits etc., in accordance with these
instructions and in the manner
intended for the particular type of
power tool, taking into account the
working conditions and the work to be
performed.
Use of the power tool for operations differ-
ent from intended could result in a hazard-
ous situation.
5.
Service
a.
Please use a qualified expert who uses
original replacement parts to repair
your power tool.
This will ensure proper functioning of the
power tool.
ADDITIONAL SAFETY INSTRUCTIONS
FOR BATTERIES AND CHARGERS
Please note the included General
Safety Notes and the following
safety notes to avoid malfunctions,
damage or physical injury:
Batteries
Never attempt to open for any reason.
Do not expose the battery to water.
Do not expose the battery to heat.
26-03-15 09:11

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

7062267

Table des Matières