Overview; Use - Eurotops 08324 Mode D'emploi

EN

Overview

1
9
8
7
6

Use

PLEASE NOTE!
■ Do not leave the heated underblanket switched on for longer than 12 hours without
interruption.
■ Do not place the controller and the cables on the switched-on heated underblanket
and do not cover it to prevent these components from overheating.
1. Spread out the heated underblanket on the mattress (It has no fasteners.). It should
rest taut and not have any creases. Note the following when doing this: Place the
heated underblanket down so that it does not subsequently rest beneath the
pillow. The socket (4) should be located at the top end at the edge of the mat-
tress so that the controller (1) is easily accessible and does not slip under the duvet.
2. In order to fi x the underblanket, cover it with a bed sheet and put the edges of the
bed sheet under the mattress. Then, place the pillows and duvet on the bed sheet.
6. When you are lying in bed, you should reduce the temperature and move to heat
level •. However, this is only a recommendation.
7. After use, slide the operating switch to position 0 and pull the mains plug out of the
plug socket.
08324_de-en-fr-nl_A5_V2.indb 16 08324_de-en-fr-nl_A5_V2.indb 16
16
1 Controller
2 Bed surface with heating loops
3 Clip
2
4 Socket for the connecting plug
5 Operating switch for switching on and
off the heat level • (1), •• (2) or ••• (3)
6 Mains cable
7 Operating status display (0 off, 1 low
heat level, 2 medium heat level, 3
highest heat level)
3
8 Connecting plug
4
9 Connecting cable
5
3. Plug the connecting plug (8) of the controller into the sock-
et and close the clip (3).
4. Connect the mains plug to an easily accessible plug sock-
et which corresponds to the technical data of the controller
(see the "Technical Data" chapter).
5. Roughly half an hour before going to bed, switch on the
device at the highest heat level to preheat the bed. To do
this, slide the operating switch (5) to the ••• position.
21.06.2018 14:43:12 21.06.2018 14:43:12