Troubleshooting - Lattoflex 292 Instructions De Montage Et D'utilisation

Troubleshooting

Jack assignment
1 2 3 4 5 6
Head
1
2 Back
Thigh
3
Calf
4
Inclined body position
5
Lumbar support
6
Frame does not react
Cause
Mains plug disconnected/
mains lead interrupted.
Socket without power.
Remote control mixed up.
Remote control no longer in teach-in status.
Control overheated because of continuous
operation. Beep sounds when activated.
Remote control does not react, no display or keyboard lighting
Cause
Batteries flat
Batteries incorrectly inserted.
Remote control disabled.
Remote control defective.
12
7 8 9
10 11
Hot-water bottle
7
8 Synchronous cable/
cable hand switch
9 Emergency lowering block
Massage
10
Underbed lighting
11
Mains lead
12
Remedy
Connect mains plug / check plug connections
on the mains adapter.
Check house fuse.
Repeat teach-in process for remote control.
Leave to cool down for approx. 20 min.
Remedy
Change batteries, 3 x AAA.
Remove batteries, insert correctly.
Check + and -.
See marking in housing.
Remove a battery and insert it again.
Replace remote control.
14
One of the motors is not working
Cause
The motor cannot be selected on the remote
control
Plug not inserted correctly in jack / discon-
nected.
One of the motors has overheated because
of continuous operation.
One of the jacks on the control unit is
defective.
Motor defective.
Emergency lowering does not react
Cause
Emergency lowering block plug not inserted
correctly in the jack
Batteries in emergency lowering block are
flat.
No lowering of back and/or thigh motor
Cause
Frame collides with resistance and is swit-
ched off by the fuse.
If you cannot solve the problem, please contact your Lattoflex
dealer. If the remote control is still working, it can help to send
the system data to Lattoflex. These can be found on the „Info"
display in the „Settings" menu. If possible, send a photo of the
screen content. This information will be helpful in making a quick
analysis of the problem.
Remedy
Repeat teach-in process for remote control.
Insert plug as far as it will go.
Leave to cool down for approx. 20 min.
Connect motor to another jack. See jack
assignment on the left. Use the remote
control to select the corresponding frame
part and test the motor.
Replace the motor.
Remedy
Insert plug in jack 9 as far as it will go.
Replace batteries, 2 x 9V block (6LR61)
Remedy
Raise motors and remove resistance
15