E- Technical Features - SCS Sentinel prim' OneGate 3 MCO0062 Notice D'utilisation Et D'installation

Photocells 1
H
function
L Stop command
Remote control
P
function
D4- Testing and checking
Make sure the general safety precaution «WARNING» has been carefully observed :
• Release the gearmotor with the proper release key.
• Make sure the gate can be moved manually during opening and closing phases with a force of max
390N (40 kg approx).
• Lock the gearmotor.
• Using the key selector switch, push button device or the radio transmitter, test the opening, closing and stopping
of the gate and make sure the gate is in the intended direction.
• Check the devices one by one (photocells, blinker, key selector, etc.) and confirm the control unit recognizes
each device.
D5- Recognition of LED
LED indications
LED 1 Photocells
LED 2 Photocells

E- TECHNICAL FEATURES

E- TECHNICAL FEATURES
Motor
Motor
Gear Type
Motor Speed
Maximum gate weight/ Maximum gate length
Operating temperature
Speed
Dimensions
34 EN
H-0
H-1
L-0
L-1
P-1
P-2
Descriptions
The LED1 turns on, when there is an obstacle between the photocells or an aligning
defect or a connection defect (Be carefull, function H must be activated with a connected
photocell on PH1).
The LED2 turns on, when there is an obstacle between the photocells or an aligning
defect or a connection defect (Be carefull, function J must be activated with a connected
photocell on PH2).
Stand-by
The factory setting is « H-0 »
Ready
Close
The factory setting is « L-0 »
Exit 11 and 12
Open
Close
The factory setting is « P-1 »
Open
motor 12V DC
sliding
2600 rpm/min
400 kg / 4 m
-20°C~+50°C
23.10 cm/s
309 mm x 157 mm x 308 mm