Adaptec SCSI CARD 29320A Guide D'installation page 11

2
Plug one end of the cable to the 50-pin internal SE Narrow SCSI
connector on the Adaptec SCSI Card 29320A.
3
Plug the other end of the cable to a terminated Ultra/Fast
Narrow SCSI device.
4
If you have other Ultra/Fast Narrow SCSI devices, attach them
to the connectors between the two ends of the cable. Be sure
these other devices are unterminated.
5
Connect a power cable from your computer's internal power
supply to each internal device.
Connecting External SCSI Devices
You can connect external Ultra320/160 and Ultra2 SCSI devices to
the 68-pin external LVD SCSI connector. Each external device will
require a 68-pin LVD external LVD SCSI cable.
Note: We recommend that you do not combine older SCSI
devices with the newer Ultra320/160 and Ultra2 SCSI devices
on the same SCSI channel of the Adaptec SCSI Card 29320A.
Follow these steps to connect your external SCSI devices:
1
Connect one end of an external SCSI cable to one of the external
Ultra320/160 connectors on the Adaptec SCSI Card 29320A.
68-pin external
LVD SCSI connector
External LVD SCSI
cable
8